Moles of the endo conformer are present in the effluent

Assignment Help Mechanical Engineering
Reference no: EM13719892

Cyclopentadiene and cyclohexanone are combined in a reactor and undergo an addition reaction.  The adduct can either have an endo or exo conformation.  For the application your plant has only the endo conformation is desired.  The selectivity of the reaction is 150.  The yield is 0.9.  The reactants are fed to the reactor at a rate of 400 mol/hour each.

a) How many moles of the endo conformer are present in the effluent?

b) How many moles of the exo conformer are present in the effluent?

c) How many moes of unreached cyclohexanone and cyclopentadiene are present in the effluent?

Reference no: EM13719892

Questions Cloud

Piston-cylinder arrangement has a load on the piston : A piston/cylinder arrangement has a load on the piston so it maintains constant pressure. It intially contains 1kg of steam at 500kPa and 50% quality. Heat from a reservoir at 700 C brings the temperature of the steam to 600 C.
What changes about the waves patterns : On the water simulation, what does the crest (peak) of the wave look like in the top view? What does the trough look like, When you add two drips, what changes about the waves' patterns
Using the average-end area-method : Determine the quantity of asphalt and granular material required for the parking lot. The asphalt is 4 inches thick and granular material is 8 inches thick.
What is the pressure that the pump can deliver : 4 kW motor is driving an oil pump with an efficiency of 95% in a 10 mm diameter pipe. If the velocities of the fluid in the pipe is 1.8 m/s. What is the flow rate that the pump delivers?
Moles of the endo conformer are present in the effluent : Cyclopentadiene and cyclohexanone are combined in a reactor and undergo an addition reaction.  The adduct can either have an endo or exo conformation.  For the application your plant has only the endo conformation is desired.
How many pump stations would be needed for a pipeline : 200mm DN pipeline has to deliver 80m³/h of water at a discharge pressure of  5,550 kPa. Approximately how many pump stations would be needed for a pipeline 300km long?
Pole-vaulter is holding the vaulting pole parallel : A pole-vaulter is holding the vaulting pole parallel to the ground. the pole is 5 m long. The vaulter grips the pole with his right hand at the top end of the pole and with his left hand 1 m from the top end of the pole. the mass of the pole is 2.5 k..
Find the frequency of the radiation of maximum intensity : The walls of a blackbody cavity are at a temperature of 27oC. What is the frequency of the radiation of maximum intensity
A closed system consists of an ideal gas : A closed system consists of an ideal gas with constant specific heats that remain constant. The gas undergoes a process in which the temperature increases from T1 to T2.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the work done and the final temperature for the

calculate the work done and the final temperature for the following processespolytropic n 1.0 1.0 kg of air t1 1470

  Determine the maximum possible volume flow rate for this

a 5 kw pump operating at steady state receives liquid water at 100 kpa 15 c and delivers it to a point 6 m above the

  Compare inlet steam mass and volume flow rates in pound mass

Compare the inlet steam mass and volume flow rates in pound mass per second and cubic feet per second of (a) a fossil-fuel power plant turbine having a polytropic efficiency of 0.90 and receiving steam at 2400 PSIA and 1000F and (b) a nuclear power p..

  A food department is kept at -15 degrees celsius by a

a food department is kept at -15 degrees celsius by a refrigerator in an environment at 25 degrees celsius. the total

  If the partial pressure of nitrogen is 115 kpa find the

a 10-m3 rigid tank contains an ideal gas mixture of nitrogen and carbondioxide at 135 kpa and 275 k. if the partial

  Consider the 2-dimensional flow field for which uaxy vby2

consider the 2-dimensional flow field for which uaxy vby2 where a1m-1 x s-1 b-0.5m-1 x s-1 and the coordinates are

  How long did the electric heating system run that night how

a passive solar house that is losing heat to the outdoors at an average rate of 50000 kjh is maintained at 22 c at all

  Consider a 300 mm x 300 mm window in an aircraft for a

consider a 300 mm x 300 mm window in an aircraft. for a temperature difference of 80oc from the inner to the outer

  An airplane traveling at 400 mph makes a 90-degree turn

an airplane traveling at 400 mph makes a 90-degree turn about a 2000 ft radius. calculate the average acceleration in

  Required ratio of mass flow rate of superheated steam

Superheated steam at 400°C and saturated water with a quality of 40% enter a mixing chamber at a pressure of 100 kPa. What is the required ratio of mass flow rate of superheated steam to mass flow rater of saturated water if at the exit to the mixin..

  The collector transfers heat by natural convection to the

a flat plate solar collector 6 ft by 12 ft is mounted on the roof of a house. the outer surface of the collector is at

  Determine a the temperature of the refrigerant exiting the

refrigerant 134a at -10degc 1.4 bar and a mass flow rate of 280 kghr enters an insulated compressor operating at steady

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd