User Account

All Pages

Minimum values for the stabilized load voltage

Assignment Help Electrical Engineering
Reference no: EM131085148

A stabilization circuit has a stability factor of 0.04 and an internal resistance of 5 Ω. The unstabilized voltage can vary between 75 and 100 V, and the load current can vary from 40 to 80 mA. Determine the maximum and minimum values for the stabilized load voltage.

Reference no: EM131085148

Questions Cloud

Energy stored per cubic metre of the dielectric : A 400 pF capacitor is charged to a p.d. of 100 V. The dielectric has a cross-sectional area of 200 cm2 and a relative permittivity of 2.3. Calculate the energy stored per cubic metre of the dielectric.
What are its revenues and medical costs : An insurer sold 100,000 policies at $6,800 and paid for all care. Ten percent of its customers were high risk ($50,000 in annual spending) and 90 percent were low risk ($500 in annual spending). What are its revenues and medical costs?
Utilize to ensure compliance by nonresident shareholders : Do most states recognize an S Election for state income tax purposes? What methods do states recognizing S status utilize to ensure compliance by nonresident shareholders?
Competitive markets changed the efficiency of these markets : Adam Smith, usually referred to as the father of economics, expounded the theory of free markets and opposed any form of concentration of economic power. What are some of the reasons for this failure? Has government intervention into competitive mark..
Minimum values for the stabilized load voltage : A stabilization circuit has a stability factor of 0.04 and an internal resistance of 5 Ω. The unstabilized voltage can vary between 75 and 100 V, and the load current can vary from 40 to 80 mA. Determine the maximum and minimum values for the stabil..
Determine the current-voltage and power gains : The input signal consists of an e.m.f. of 60 mV from a source of internal resistance 2.2 kΩ, and the total load on the stage output is 4 kΩ. Determine the current, voltage and power gains of the amplifier stage.
Two technologies for producing output : You are the manager of a new firm that can choose between two technologies for producing output using only labor. Technology A can produce two units of output for each hour of labor input. Technology B can produce three units of output for each hour ..
Voltage gain of the basic amplifier : What percentage change in the voltage gain with feedback would be produced by a 50 per cent change in the voltage gain of the basic amplifier due to a change in the load? The loading effect of the feedback network can be neglected.
Find a maximum flow in the network : Find a maximum flow in the network below from the source S to the sink T. Justify that your flow is a maximum flow

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain logic high level

Three two-input "AND" gates have their outputs connected to an "OR" gate. The first "AND" gate has each of its inputs at logic HIGH level. The second "AND" gate has each of it's inputs at logic LOW level.

  Find an expression for load current up to fifth harmonic

A single phase full bridge inverter feds power at 50Hz to RLC load with r=5 ohms , l=0.3H and C=50μF. The dc input voltage is 220volts. (a) Find an expression for load current up to fifth harmonic

  Define what is the maximum symbol rate

What is the maximum symbol rate for this link and the number of bits per symbol? What format would you recommend for the transmitted current pulses on this baseband link?

  Calculate the load voltage-load power and the efficiency

Calculate the load voltage, the load power, and the efficiency of the transmission system under the following schemes. a. 4:1 transformer at generator b. 4:1 transformer to load c. 1:4 transformer at the generator and a 16:1 transformer at the loa..

  What is the cost of the operation for 30 days

A 1.8-kW electric heater takes 15 min to boil a quantity of water. If this is done once a day and power costs 10 cents/kWh, what is the cost of its operation for 30 days

  The voltage drops across three resistors in series are

the voltage drops across three resistors in series are measured to be 10.0v 15.0v and 25.0v. if the largest resistor

  Find line voltage at the source with a balanced 3-phase load

A balanced 3-phase load takes 5.4 kW at 0.6 lagging power factor. If this load is connected through lines having 2 ohms resistance and 2ohms inductive reactance. Find the line voltage at the source. The line voltage at the load is 208 volts.

  Give the polar plot of the frequency response

1. Sketch the polar plot of the frequency response for the following loop transfer functions: Gc(s)G(s) = 1 / ((1 + 0.25s)(1 + 3s)) Gc(s)G(s) = 5(s^2 + 1.4s + 1) / (s - 1)^2 Gc(s)G(s) = (s - 8) / (s^2 + 6s + 8) Gc(s)G(s) = 20(s + 8) / (s(s +2)(s + 2)..

  Use laplace transform techniques

Use Laplace transform techniques to find the solution to the following differential equation given that x = 1/3 at t = 0.

  Compute the equilibrium carrier concentrations

Compute the equilibrium carrier concentrations and the position of the Fermi level with respect to the conduction band edge for a uniformly doped Si region with N_D=1*10^16 cm^-3 and N_A = 1*10^17 cm^-3 at room temperature.

  Determine the relative permeability of the torroid

The cast steel torroid shown below has a rectangular cross-section. If the flux in the core is known to be 7.75mWb and the coil has 200 turns, determine the current in the coil. dimensions on the torrid. 300mm id; 400mm od; 100mm tall

  Determine r-l-g and c for the line

A lossy transmission line at 1GHz has the following characteristics: Z0= 50.0 ohms alpha= 0.01 dB/m, Betta=8 rad/m. Determine R, L, G and C for the line

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd