Meteorologist uses pitot-static tube to measure wind speed

Assignment Help Mechanical Engineering

Reference no: EM13704536

A meteorologist uses a pitot -static tube to measure the wind speed in a tornado. Based on the damage caused by the storm, the tornado is rated as EF5 on the enhanced Fujita Scale. This means that the wind speed is estimated to be in the range of 261 to 381 mph. is it reasonable to use the incompressible pitot-tube equation (3.16) to determine the actual wind speed, or must compressible effects to taken into account? Explain

Reference no: EM13704536

Questions Cloud

Air enters a gas turbine of an air-standard brayton cycle : Air enters a gas turbine of an air-standard Brayton cycle at 1000 kPa, 1000 K, and expands to 100 kPa in two stages. The air is reheated between the stages at a constant pressure of 400 kPa to 1000 K. The compressor work input is given as 250 kJ/kg.

Piston-cylinder device with set of stops initially contains : A piston-cylinder device with a set of stops initially contains 0.6kg of steam at 0.8MPa and 500Â°C. The location of the stops corresponds to 60percent of the initial volume. Now the steam is cooled. Determine the compression work of the final state ..

Assuming constant specific heat at room temperature : A Stirling cycle operates with 1 kg of air between thermal energy reservoirs at 27oC and 527oC. The maximum cycle pressure is 2000 kPa and the minimum is 100 kPa. Assuming constant specific heat at room temperature,

Sheet of epoxy reinforced : A sheet of epoxy reinforced with 60% unidirectional E-glass fibers, where x is the fiber direction. Strains ex= 0.0030, ey=-0.0020, and yxy = .0025 are measured. Estimate the applied stress ox, oy, txy

Meteorologist uses pitot-static tube to measure wind speed : A meteorologist uses a pitot -static tube to measure the wind speed in a tornado. Based on the damage caused by the storm, the tornado is rated as EF5 on the enhanced Fujita Scale. This means that the wind speed is estimated to be in the range of 261..

What is the maximum rated engine speed : You are designing a 4-stroke cycle diesel engine to provide a brake power of 300 kW naturally aspirated at its maximum rated speed. Based on typical values for BMEP and mean piston speed, estimate the required engine displacement, and the bore and st..

Diameter alloy rod has elongated-diameter has been reduced : At the proportional limit, a 1.5-in. gage length of a 0.375-in.-diameter alloy rod has elongated 0.0081 in. and the diameter has been reduced 0.00071 in. The total tension force on the rod was 5.62 kips.

A hypothetical metal has hcp crystal structure with ideal : A hypothetical metal has an HCP crystal structure with the ideal c/a ratio (1.633). What is the volume of its unit cell, if the atomic radius is 1.3A?

Determine the tension in cable ac : The boom OA carries a load P and is supported by two cables as shown. Knowing that the tension in cable AB is 183 lb and that the resultant of the load P and of the forces exerted at A by the two cables must be directed along OA, determine the tensio..

User Account

All Pages