Reference no: EM13711541
Can you please paraphrase for me the whole report that i'm going to send you and please only paraphrase and leave all the tables and the figures as they are ... thanks
Project Description and Background
Aim
Throughout this experiment there will be a number of different aims that will ideally be covered.
a) To measure the horizontal distance (lengths) of traverse legs using pacing, surveyor's tape and total station
b) To measure vertical distances (elevation) of transverse stations K using an automatic level
c) To measure the coordinates of points B and C using total station (where coordinates
of are provided) and to take a number of measurements covering the whole area (side of library building, concrete footpaths, tree and any other important features) that help to prepare a topographical map of the survey area.
Also use total station to measure a number of quantities specified in the total station field notes
d) To familiarise with the use of GPS to measure coordinates and other computations (i.e. Slope and horizontal distances, area, perimeters etc.)
|
Maximum shear stress can be adequately approximated
: The maximum torque produced by the engine of the car occurs at 4750 rpm, when the engine is generating 286 HP. The designer followed the following method and chosen steel shaft having yiled stress at 80,000 psi and a factor of safety = 4.
|
|
What is the gauge pressure in the container
: A rigid adiabatic container in a room with a barometric pressure of 100 kPa is divided into two unequal volumes as shown. V1 = 0.108 m3 and contains air (R = 0.2870 kJ/kg-K, k = 1.40) at a gauge pressure of 32 kPa and temperature of -3°C.
|
|
What rate is heat rejected from this engine as waste heat
: An engine burns 200 cubic feet per hour of natural gas with a heating value of 1000 btu/cubic feet. The engine produces 39.1 horsepower for this test. What is the average efficiency for this test? At what rate (btu/h) is heat rejected from this engin..
|
|
Shell-and-tube heat exchanger is used to cool flow of steam
: A shell-and-tube heat exchanger is used to cool a flow of steam using a stream of cooling water. The steam enters the heat exchanger at 0.1 bar and a quality of 91% (state 1), and exits as a saturated liquid at the same pressure (state 2). The mass f..
|
|
Measure the horizontal distance lengths of traverse
: Measure the horizontal distance lengths of traverse legs using pacing, surveyor's tape and total station - familiarise with the use of GPS to measure coordinates and other computations (i.e. Slope and horizontal distances, area, perimeters etc.)
|
|
What is its initial pressure
: An airplane pilot is about to leave a long cross-country trip that will require him to use oxygen. He's noticed that the amount of oxygen in the bottle in the plane is low, so he must refill it from the large supply tank of oxygen in his hanger. The ..
|
|
Measure the horizontal distance lengths of traverse
: Measure the horizontal distance lengths of traverse legs using pacing, surveyor's tape and total station - familiarise with the use of GPS to measure coordinates and other computations (i.e. Slope and horizontal distances, area, perimeters etc.)
|
|
Conduct the necessary marketing analysis for your strategy
: Analyze the MARKETING ENVIRONMENT. The Marketing Environment is covered in a Powerpoint presentation provided - Briefly explain what you did and indicate the sources you have used.
|
|
Change in enthalpy of oxygen as temperature changes
: What is the change in enthalpy (in kJ/kg) of oxygen as its temperature changes from 29°C to 181°C? Assume an ideal gas with R = 0.2598 kJ/kg-K and a ratio of specific heats of 1.4.
|