Maximum shearing stress in cylinder after-internal pressure

Assignment Help Mechanical Engineering

Reference no: EM13707395

A laminated thick-walled cylinder was fabricated by shrinking a steel (E=200 GPa and nu=0.03) sleeve having an inside diameter of 199.800mm and an outside diameter of 300mm onto a steel tube with an inside diameter of 100mm and an outside diameter of 200mm. Determine the maximum shearing stress in the cylinder after and internal pressure of 270 MPa is applied.

Reference no: EM13707395

Questions Cloud

Helium gas is contained in a rigid vessel : Helium gas is contained in a rigid vessel of 0.5 m3 at 500 kPa. The gas is agitated violently by a stirrer that transfers 250 kJ of work to the gas. Assuming that the system undergoes an adiabatic process, determine the final pressure of the gas. Ass..

What is the internal energy of the gas after the expansion : The amount of heat (dh = 327.18 KJ) is added to an open volume of 1m3 of air (at standard sea level conditions), causing it to expand to 4 m3. How much work is done by the air? What is the internal energy of the gas after the expansion?

Determine the heat transferred to and the work produced : Steam at 75 kPa and 13 percent quality is contained in a spring-loaded piston-cylinder device, as shown in the figure, with an initial volume of 5.28 m^3. Steam is now heated until its volume is 13.20 m^3 and its pressure is 300 kPa. Determine the he..

What equivalence ratio for octane-air mixtures : At what equivalence ratio for octane-air mixtures does the carbon to oxygen ratio of the system equal one? Why is this of interest?

Maximum shearing stress in cylinder after-internal pressure : A laminated thick-walled cylinder was fabricated by shrinking a steel (E=200 GPa and nu=0.03) sleeve having an inside diameter of 199.800mm and an outside diameter of 300mm onto a steel tube with an inside diameter of 100mm and an outside diameter of..

Compare inlet steam mass and volume flow rates in pound mass : Compare the inlet steam mass and volume flow rates in pound mass per second and cubic feet per second of (a) a fossil-fuel power plant turbine having a polytropic efficiency of 0.90 and receiving steam at 2400 PSIA and 1000F and (b) a nuclear power p..

Tire depends on the temperature of the air in the tire : The pressure in a tire depends on the temperature of the air in the tire. The gage pressure of an automobile tire with a volume of 0.025 m3 is measured to be 210 kPa at 25 oC at sea level on a day with calm weather. If the temperature of the air in t..

The mass flow rate of the air and exit velocity of the air : Air enters an 8” diameter pipe at atmospheric pressure at a velocity of 30 ft/s and 65 F and exits at approximately the same pressure. While in the pipe, the air passes over a heat exchanger that causes its temperature to increase by 25 F.

The initial interference required to produce : A laminated steel (E=200 GPa and nu=0.3) cylinder consists of a jacket with an inside diameter of 250mm and an outside diameter of 300mm shrunk onto a tube with an inside diameter of 150mm. The initial shrinkage pressure is 28MPa.

User Account

All Pages