Maximum normal stress and the maximum shear stress

Assignment Help Mechanical Engineering

Reference no: EM13708161

A thin walled tube with closed ends has an inside radius of 80mm and a wall thickness of 6 mm. It is subjected to an internal pressure of 20 MPa, a torque of 60 kN*m, and an axial compressive force of 200 kN. Determine the maximum normal stress and the maximum shear stress.

Reference no: EM13708161

Questions Cloud

Calculate the amount of heat transfer for the processes : Two kilograms of Refrigerant 134a, initially at 200 kPa and occupying a volume of 0.11874 m3, undergoes a process at constant pressure until the volume has doubled. Kinetic and potential energy effects are negligible.

Diffusion of carbon-what depth would the concentration : Diffusion of carbon into BCC iron for 12 hours at a temperature of 5000C results in a carbon concentration of 0.2 wt% at a depth 2 mm from the surface. At what depth would the concentration be 0.2 wt%, if the diffusion occurred for 6 hours at 8000C?

Reduce the mass of an aluminium bulkhead for a spacecraft : In an effort to reduce the mass of an aluminium bulkhead for a spacecraft, a machinist drills an array of holes in the bulkhead. The bulkhead is a triangular-shaped plate with a base and height of 2.5 m and 1.6 m, respectively, and a thickness of 7 m..

Determine the axial stress required to induce this strain : An aluminium bar is subjected to uniaxial tensile loading. If the lateral strain (perpendicular to the load direction) is measured to be -0.00025, determine the axial stress required to induce this strain (round to the nearest ksi).

Maximum normal stress and the maximum shear stress : A thin walled tube with closed ends has an inside radius of 80mm and a wall thickness of 6 mm. It is subjected to an internal pressure of 20 MPa, a torque of 60 kN*m, and an axial compressive force of 200 kN. Determine the maximum normal stress and t..

Determine the volumetric flow rates at the inlet and exit : Refrigerant 22 enters an insulated compressor operating at steady state as saturated vapor at - 16 C with a mass flow rate of 1.5 kg/s. Refrigerant exits at 7 bar, 70 C. Changes in KE and PE from inlet to exit can be ignored. Determine: (a) the volum..

Calculate displacement-velocity-acceleration for assembly : A certain piston cylinder assembly has a stroke of 85mm, a connection rod length of 130 mm and a piston pin offset of 2mm. Calculate the displacement, velocity and acceleration of the assembly operating at 2200 RPM. If the same configuration is used ..

Drip irrigation problem : Drip irrigation is a means of getting water directly to growing plants with very little waste. One method uses a large-diameter polyethylene "mother" tube (10-15 mm i.d.) from which lead many small diameter polyethylene feeder tubes, called drippers,..

Block of copper at at initial temperature : A 25-kg block of copper at at initial temperature of 150 C equilibrates with 0.79 kg of liquid water at an initial temperature of 20 C in an insulated tank. If the average specific heat of copper can be taken to be 0.395 kJ/kg.K, determine the final ..

User Account

All Pages