Maximum height for stable equilibrium in upright position

Assignment Help Mechanical Engineering
Reference no: EM13993981

A solid block of wood weighs 62290 N/m^3. It is in a shape of rectangular parallelepiped having a 10 cm square base.

If the boat floats in fresh water with the square base horizontal, what is its maximum height for stable equilibrium in upright position?

Reference no: EM13993981

Questions Cloud

What is the self-help doctrine : What is the self-help doctrine? When is this used in criminal law
Which ones offer the subsidiary the most and least independ : Of the various methods by which a corporate subsidiary can be separated from the parent company in the public markets (IPO, carve-out, spin-off, split-off, and tracking stock), which ones offer the subsidiary the most and least independence?
Does the board sit in fresh water : A paddleboard is 12 ft long, 18 inches wide, 4.0 inches thick, and weighs 15 pounds. If the surfer weighs 170 pounds, how deep, in inches, does the board sit in fresh water?
What legal claims and defenses should be asserted : What legal claims and defenses should be asserted in a suit by Professor Smitt against Justin, Ed, and the Daily Times, and how should the claims and defenses be resolved? Discuss
Maximum height for stable equilibrium in upright position : A solid block of wood weighs 62290 N/m^3. It is in a shape of rectangular parallelepiped having a 10 cm square base.If the boat floats in fresh water with the square base horizontal, what is its maximum height for stable equilibrium in upright positi..
Fows through a constant-diameter pipe : Oil (specific gravity, 0.8)  flows through a constant-diameter pipe-(pipe diameter,  D=3 inches)  that goes through a bend of angle,  θ=45°   The flow rate in the pipe is  0.12 ft3 /s.  The pressure in the pipe atAandBis  the same, namely, 11 psi . T..
Calculate the net electric force exerted on q1 : Three point charges are located at the corners of an equilateral triangle as shown. Each leg of the triangle has a length of 1.38 meters. And the charges have values as follows. Q1 = 4.61 microcoulombs, Q2 = - 8.69 microcoulombs, and Q3 = -6.09 m..
Prepares and provides assistance to law enforcement agencies : Discuss how the DHS prepares and provides assistance to law enforcement agencies. Conclude with a paragraph that addresses your own thoughts on this agency's inception and current effectiveness
Write the six risk-neutral probability weights : Write the value of the stock on the tree where pre-mature exercise of the American put is optimal. Report "0" if premature exercise of the option is not optimal.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Assume ends of bar in 5-7 have been kept constanst at 100

assume ends of bar in 5-7 have been kept constanst at 100 degrees c for a long time. then at some instant t0 the

  The exit mass flowrate during this condition is constant at

an accident at a nuclear power plant causes the main valves to close and stop the main water flow that cools the

  Find the maximum value of the principal stress and find the

a carbon steel ball with a diameter of 50 mm rests in a stainless steel hemispherical socket with a diameter of 60 mm.

  What are the common application of statics in industry

What are the common application of statics in industry

  Volume flow rate of the refrigerant at the compressor inlet

Refrigerant-134a enters an adiabatic compressor as saturated vapor at -24 degrees Celsius and leaves at 0.8 Mpa and 60 degrees Celsius. The mass flow rate of the refrigerant is 1.2 kg/s. Determine (a) the power input to the compressor and (b) the vol..

  How far up the incline will they go

A 16 lb bowling ball is rolled at a speed of 12 ft/sec toward a 10 lb sled that sits on a 45o in-cline. Once it hits the sled, it rolls up the incline inside of it. How far up the incline will they go?

  Determine the net power output developed by the turbine in

steam at 160 bar 520 degrees celsius and with a mass flow rate of 250 kgs enters a turbine operating at steady state

  The initial volume is 01 m3 the final volume is 004 m3 and

a gas in a piston-cylinder assembly undergoes a compression process for which the relation between pressure and volume

  Derive equation for pressure to push pig through pipe line

Derive equation for pressure to push pig through pipe line. A 20" diameter pipe is 7243 meters long and is being cleaned by a pig apparatus. Derive an equation for the required pressure given by a compressor to push a pig through a pipe while it push..

  Its specific heat ratio is 14 and gas constant is 0287

an open brayton cycle engine operates with a compressor-pressure ratio of 6 an inlet temperature of 20 c and inlet

  Calculate the inside temperature when the outer surface is

the inside dimensions of a refrigerated box is 2m x 1 m x 1.2 m. it is covered with insulation 50 mm thick and then a

  Determine the amount of heat transferred to the air in kj

4-81 air is contained in a cylinder device fitted with a piston-cylinder. the piston initially rest on a set of stops

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd