Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
What is the magnetic ?ux density at a distance of 0.1 m from a wire that carries a current of 0.35 A?
A network connected between terminlas a and b consists of two parallel combinations that are in series. The first parallel combination is composed of a 10 OHM resistor and a 19 OHM resistor.
For the LCD, describe the function accomplished with the RS control signal. Also, indicate whether this signal is an LCD input or LCD output. Describe how the 74C922 IC operates and its interface between the keypad and the microcontroller.
A three phase Y-connected 220-Volt 10-Hp, 60Hz, 6-pole induction motor has the following constants in Ohms per phase referred to the stator. R1=0.294, R2=0.144, X1=0.503, X2=0.209, Xm=13.25.
Characterize the environment as being accessible, deterministic, episodic, static, and continuous or not. What agent architecture is best for this domain?
The battery voltage is 20V Resistor3 a resistance of 20ohms. Resistor1 has a resistance of 30. Current flow is 250mA through the circuit. What is the resistance of resistor 3
Three equal point charges Q form the corners of an equilateral triangle of side length "a". How much work is required to move one of the charges to a point half-way between the other two.
build a cicuit that must be able to operate a 3 amp load of the LED while being able to operate at voltages around 3V or 6V. It must be able to keep the LED on constantly while also being able to pulse the LED.
The collector current was measured for different values of load resistance. It was noticed that the collector current was pretty much constant for the first 1900 ohms and then it fell drastically.
On a breadboards, hook up an IR LED to provide an infrared light source for signaling the phototransistor as shown in Figure 2 below. Use a pushbutton switch to turn the IR LED on and off.
Determine which of these properties hold and which do not hold for each of the following continuous-time systems.Justify your answer. In each example,y(t) denotes the system output and x(t) is the system input. (a) y(t)= x(t-2)+x(2-t) (b) y(t)= (c..
A 10 MHz crystal has a negative temperature coefficient of 4.1Hz/MHz/Co. Determine the crystal frequency if the temperature decreases by 41 degrees.
Four 1/2 W resistors are in series: 49-ohm , 64-ohm,109-ohm , and 125-ohm . To what maximum value can the current be raised before the power rating ofone of the resistors is exceeded
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd