Low-speed wind tunnel with atmospheric air

Assignment Help Mechanical Engineering

Reference no: EM13701063

A fan that can provide air speeds up to 50 m/s is to be used in a low-speed wind tunnel with atmospheric air at 25°C. If one wishes to use the wind tunnel to study flat-plate boundary layer behaviour up to Reynolds numbers of Rex = 10^8 , what is the minimum plate length that should be used? At what distance from the leading edge would transition occur if the critical Reynolds number were Rex, c = 5x10^5?

Reference no: EM13701063

Questions Cloud

Compute the complex dynamic shear modulus : Binder Classification (Grading) What is the best possible PG grade of the asphalt whose results are shown in Table 4 below? Use Table 9.3 from M&Z at end of assignment to help.

Thermal energy reservoirs : Consider a Carnot heat engine and a refrigerator operating between the same two thermal energy reservoirs. If the thermal efficiency of the heat engine is 0.80, the COP of the refrigerator is?

Find number of independent dimensionless parameters : Pressurised tank drained through a smooth nozzle, area A m(dot) = m(dot)(del p ,h, row, A, g) Find: number of independent dimensionless parameters. obtain the parameters

Compute the force needed to completely submerge the object : Calculate the 2x4 Block's Weight, mass, density and Specific Weight. Express values in both metric and US units. Compute the force needed to completely submerge the object.

Low-speed wind tunnel with atmospheric air : A fan that can provide air speeds up to 50 m/s is to be used in a low-speed wind tunnel with atmospheric air at 25°C. If one wishes to use the wind tunnel to study flat-plate boundary layer behaviour up to Reynolds numbers of Rex = 10^8 , what is the..

Where the hydrodynamic boundary layers meet : Air at 20°C flows at 1 m/s between two parallel flat plates spaced 5 cm apart. Estimate the distance from the entrance where the hydrodynamic boundary layers meet.

What is the equation for the actual air temperature : An electric heater heats air. The temperature sensor has a time constant of 5 seconds. The air temperature output (in °C), as measured by the temperature probe is: T=200+cos(0.5t)

Force required to keep the cart moving at constant velocity : A 2 cm horizontal jet of water with a velocity of 15 m/s is spraying onto a vertical plate attached to a cart moving opposite the direction of the water jet at 8 m/s. Determine the force required to keep the cart moving at a constant velocity.

Distillery uses mechanical vapour re-compression : The wash still in a whisky distillery uses mechanical vapour re-compression as shown in the simplified diagram of the Figure shown below. The vapour from the still is at 80° C. Take a minimum temperature difference between the vapour leaving the stil..

User Account

All Pages