Liquid octane c8h18 at 25ordmc 10 atm enters a

Assignment Help Mechanical Engineering
Reference no: EM13625413

Liquid octane (C8H18) at 25ºC, 1.0 atm enters a well-insulated reactor and reacts with air entering at the same temperature and pressure. For steady-state operation and negligible effects of kinetic and potential energy, determine the temperature of the combustion products for complete combustion with the stoichiometric amount of air.

Reference no: EM13625413

Questions Cloud

A piping system consists of 100 ft of 2-in pipe a sudden : a piping system consists of 100 ft of 2-in pipe a sudden expansion to 3-in pipe and then 50 ft of 3-in pipe. water is
A copper wire of diameter 080 mm fails at an engineering : a copper wire of diameter 0.80 mm fails at an engineering stress 248.2 mpa. its ductility is measured as 75 reduction
Determine the yield strength modulus of elasticity tensile : in a tensile test the starting gage length 100 mm and the cross-sectional area 150 mm2. during testing the following
Water flows straight down from an open faucet the : water flows straight down from an open faucet. the cross-sectional area of the faucet is 1.2 times 10-4m2 and the speed
Liquid octane c8h18 at 25ordmc 10 atm enters a : liquid octane c8h18 at 25ordmc 1.0 atm enters a well-insulated reactor and reacts with air entering at the same
Find the work done per pound of water during the expansion : water in a piston-cylinder initially starts at t 400of and p 200 psia. the piston is heated until it final volume is
As a race car approaches a fan in the stands the fan hears : as a race car approaches a fan in the stands the fan hears the noise of the engine at 323 hz. as the race car recedes
Water exiting the condenser of a power plant at 38ordmc : water exiting the condenser of a power plant at 38ordmc enters a cooling tower with a mass flow rate of 4.5 x 107 kgh.
The bar is loaded axially until it elongates 65mm and then : a bar of length 2.0 m is made of a structural steel having the stress-strain diagram shown in the figure. the yield

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The wheel radius is 46 cm and the height of the center of

a girl riding a bicycle along a level road at 12 ms decides to speed up. she does 8 kj of work while moving 250 m along

  In a compton experiment an electron attains a kinetic

in a compton experiment an electron attains a kinetic energy of 0.1 mev when a 0.5mev x-ray strikes it. determine the

  The welding department has idle capacity of 600 minutes per

a single unit of product a requires 2.4 minutes of punch press time and 5.0 minutes of assembly time. the profit for

  With all similarity conditions satisfied the measured drag

the drag on a 2-m-diameter satellite dish due to an 80-kmhr wind is to be determined through a wind tunnel test using a

  The gage fluid in the manometer has a specific weight of

a flowrate measuring device is installed in a horizontal pipe through which water is flowing. a u-tube manometer is

  Draw a schematic of band structure of a compound that has s

draw a schematic of band structure of a compound that has s and p orbitals occupied. show where is the fermi energy and

  Specify a diameter d using a design factor of nd

xerted on the shaft shown in the figure, which rotates at 1150 rev/min and supports a 10-kip bending force. Use a 1095 HR steel. Specify a diameter d using a design factor of nd = 1.6 for a life of 3 min. The surfaces are machined.

  The tank is allowed to exchange heat with the surroundings

a tank of compressed air is at 40 degrees c and 10 atm. 1 third of the gas is removed for inflating a car tire. the

  An input 422 ft-lb of torque from the torque converter

An input 422 ft-lb of torque from the torque converter.

  Calculate the angle between the wires

showing the two upward pulls of the rings on his hands, each of size 380N. Calculate the angle between the wires supporting the rings and the vertical.

  If the orifice is suddenly opened coefficient of discharge

a tank 1.5m high stands on a trolley and is full of water. it has an orifice of diameter 0.1m at 0.3m from the bottom

  The wheel in fig 10-27 has eight equally spaced spokes and

the wheel in fig. 10-27 has eight equally spaced spokes and a radius of 30 cm. it is mounted on a fixed axle and is

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd