Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In the computer experiment described in Section 10.21, we used the optimal manifold (for the unsupervised representation of data) and the least-mean-square (LMS) algorithm to perform pattern classification. The data used for the classification was based on a specific setting of the two-moon configuration depicted in Fig. 1.8.
(a) Repeat the computer experiment of Section 10.21, this time using the recursive leastsquares (RLS) algorithm in place of the LMS algorithm.
(b) Contrast the results of your experiment against those of Section 10.21 in terms of performance convergence, and computational complexity.
Figure 1.8
A radio wave that may be considered a uniform plane wave propagates through the ionosphere and interacts with some charged particles which are moving with a velocity a tenth the velocity of light in the direction normal to the magnetic field of t..
A Widlar Current Source is designed to limit the load current to the reference current by using a resistor at the emitter end by:I(load)*R(Emitter)=Vt ln (I(ref)/I(load))=VBE(Ref)-VBE(Load)
What is the minimum Eb/Ieff (bit energy over effective noise energy) to yield P(e)
A certain parallel circuit coornsists of onrely 1/2 W resistors each having the same resistance. The total resistance is 1 k ohm and the total current is 50mA. If each resistor is operating at one-half its maximum power level
A 10-watt signal is connected to a low-pass channel with bandwidth B Hz. If the channel is corrupted by additive whiteGaussian noise (AWGN) with singel-sided power spectral density of10-7 Watts/Hz.
Determine the Xc utilizing complex number representation instead of phasor representation
A 11 GHz uniform plane wave with maximum electric field of 100 V/m propagates in air in the direction of a x-direction. The magnetic field has only a a(z) component ( in the z direction), which is approximately equal to 100 mA/m at x = y = t = 0.
A sequential circuit has two inputs and two outputs. The inputs (X1X2) represent a 2-bit binary number, N. If the present value of Nis greater than the previous value, then Z1=1. If the present value of N is less than the previous value, then Z2=1..
Design a synchronous 2-bit, binary, up-counter using the following specification: The counter has five inputs ( not including the clock) and three outputs. The inputs are CLR ("Clear"), LOAD, COUNT, LB and LA.
A TDM link has 20 signal channels and each channel is sampled 8000 times/sec. Each sample is represented by seven binary bits and contains an additional bit for synchronization. what is The total bit rate for the TDM link.
For a new product sales are expected to be 2,000 products in year 1, increasing by 1,000 products each subsequent year to 5,000 products in year 4. Two different manufacturing equipment options are available a) Up front equipment purchase cost of $..
How to decide the shortest possible clock period for a synchronous circuit with the flop-based clocking. What is the hold time of a register. How does the hold time constrain the circuit delays for a synchronous circuit.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd