Is this a maximum boiling or minimum boiling azeotrope

Assignment Help Chemical Engineering
Reference no: EM131155897

Problem 8.4: Use the data below for the system ethyl propyl ether (1)-chloroform (2) to answer the following questions:

a) What is the boiling point of chloroform at 0.5 bar?

b) Is this a maximum boiling or minimum boiling azeotrope?

c) What is the composition at the azeotropic point?

d) A mixture of the two components contains 80% by mol ethyl propyl ether. What is the phase of this mixture at 48.3 °C, 0.5 bar? If a two-phase system, report the composition of the two phases and their relative amounts.

e) One mol of a solution, whose bubble point at 0.5 bar is 48.3 °C, is mixed with chloroform until the final mixture contains 50% chloroform (by mol). How much chloroform is needed?

818_090c5310-e489-4d40-932e-622f029b025c.png

Reference no: EM131155897

Questions Cloud

Problem regarding the floatation costs : How would "floatation costs" impacted the WACC, and how could they have been incorporated in the formula?
Problem regarding the floatation costs : How would "floatation costs" impacted the WACC, and how could they have been incorporated in the formula?
What type of juvenile population might be best served : Explain how each program is influenced by sociological, biological, and/or psychological factors thought to contribute to juvenile crime and delinquency. Be specific and use examples to support your explanation.
Harry davis weighted average cost of capital : 1. What sources of capital should be included when you estimate Harry Davis's weighted average cost of capital (WACC)? 2. Should the component costs be figured on a before-tax or an after-tax basis?
Is this a maximum boiling or minimum boiling azeotrope : One mol of a solution, whose bubble point at 0.5 bar is 48.3 °C, is mixed with chloroform until the final mixture contains 50% chloroform (by mol). How much chloroform is needed?
What do healthy communities have in common : What do healthy communities have in common? How would you provide care for a community if your idea of a healthy community does not match your community's definition of a healthy community?
What is the saturation pressure of methanol at 308.5 k : What is the phase of a mixture that contains 60% dioxane at 308.5 K, 0.1 bar?
Do reverse engineering under enrons market price equal value : Do the reverse engineering under the following assumptions:- Enron's market price equals value.- The consensus analysts' earnings-per-share forecasts through 2005 are reliable proxies for market expectations.
What are most important elements of the affordable care act : What are the most important elements of the Affordable Care Act in relation to community and public health? What is the role of the nurse in implementing this law?

Reviews

Write a Review

Chemical Engineering Questions & Answers

  Find the induced armature voltage at rated load

Assuming the total brush-contact drop to be 2 V, find the induced armature voltage at rated load and rated terminal voltage for

  Explain risk analysis and management

Risk Analysis and Management: Earthquake - An example of Fragility and Load, The fully formated problem is with the solution.

  Derive closed-loop transfer function relating disturbance

A system can be represented by the block diagram below: Derive (write the different steps explicitly. not just the solution!) the closed-loop transfer function relating the set point (Ysp) to the output Y

  Geometry and dimensions for a section

The geometry and dimensions for a section of the blood vessel are shown on the right. Based on the Poiseuille's law the viscous resistance against blood flow through this section is determined to be 0.0002 mmHg•s/ml. If the diameter of the vessel ..

  Find the induced emf across the coil

Calculate the average mechanical torque needed to turn the coil and generate power for the resistor. Identify the action of the device as that of a motor or a generator.

  Determine the ratio of the following in the rewound motor

Rotor resistance referred to the stator. Repeat the problem, given that the original rotor is rewound with the same number of turns as originally, but with one-half the original cross section of the conductor. Neglect the changes in the leakage fl..

  Mole fractions of benzene and toluene

How will the mole fractions of benzene and toluene in the liquid change with time (increase, decrease, or remain constant)? Explain your answer.

  Find the current that must be supplied to the coil

A toroid with a circular cross section is shown in Figure P11.2.3. It is made from cast steel with a relative permeability of 2500. The magnetic flux density in the core is 1.25 T measured at the mean diameter of the toroid.

  Find the charge flowing, and the number of electrons

Find the charge flowing, and the number of electrons per second that are passing some point in the wire.

  Identify the blood-red precipitate

Identify the ionic compounds in solution A and solution B. Identify the blood-red precipitate. Calculate the concentration (molarity) of all ions in the original solutions.

  Estimate the overall mass transfer coefficient kl

What is the molar concentration of the ammonia in the liquid at the interface?

  Determine the unknown process variables

determine the unknown process variables.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd