Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A sample of soil taken at a depth of 5 m in a homogeneous over consolidated saturated clay was testedunder standard triaxial CU conditions. Its water content was 48%. The soil was isotropically consolidated to a mean effective stress of 50 kPa and then unloaded to a mean effective stress of 15 kPa. The peak deviatoric stress reported by the soil technician is 20 kPa. The critical state friction angle is 32°. A one-dimensional consolidation test gave the following results: Cc = 0.32, Cr = 0.06, and OCR = 6. In the field, the groundwater level is at the ground surface.
(a) Is the reported peak deviatoric stress reasonable?
(b) Is the CU test, as conducted, representative of the in situ conditions? Justify your answer.
(c) Estimate the undrained shear strength of the in situ soil sample.
Estimate the stopping distance required traveling northbound along University Drive towards campus assuming you are traveling at 40 mph under normal conditions.
A piston-cylinder device contains helium gas initially at 150 kPa, 20 degrees C, and 0.5 m^3. The helium is now compressed in a polytropic process (PV^n = constant) to 400 kPa and 140 degrees C.
Sketch the geometry and orientation of the steps formed on the fracture surface.
car traveling along a circular curve that has a radius of 50m. if its speed is 16m/s and is increasing uniformly at 8 m/s^2 determine the magnitude of its acceleration at this instant
Double the width of the window, using widen, set the height of the window so that it is the same as the width, and set the title to the new value "Square Window".
The uniform load has a mass of 400 and is lifted using a uniform 40- strongback beam and four ropes. determine the tension in each rope
The structure consists of a wood frame with plywood roof deck, wall sheathing and floor deck. general form of the building construction is to be determined by the designer.
The top of the object is 1 m below the surface of the fluid. What are the magnitude and direction of the hydrostatic force acting on the top of the object.
An airplane with a Clark Y airfoil cross-section weighs 3500 lbs. The chord length is 6ft and the wingspan is 36 ft. Determine the: a) Minimum speed and power to take off, if the angle of attack is 12.4 degrees.
Design the temperature reinforcement, tie bars, and dowel bars for a highway concrete pavement with 13 inch slabs, f'c=3500 psi, traverse joints at 35 ft apar,t and with 3 12 ft lanes each way. Use grade 60 steel
You are analyzing a polymer uniaxial tension member used in a lightweight structure. The bottom of the tension member is fixed and the top has a tensile force F = 10,000 pounds on it.
The joists from the previousquestion are supported by concrete beams that are 300mm wide by 500mm deep. The concretebeams span 8.4m. Assume the beam is also simply supported. The weight of the joistis 1.04 KN/m.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd