Is it possible to compute the magnitude of the load

Reference no: EM13559271

A brass alloy has a yield strength of 280 MPa, a tensile strength of 390 MPa, and an elastic modulus of 105 GPa. A cylindrical specimen of this alloy 12.7 mm in diameter and 250 mm long is stressed in tension and found to elongate 7.6 mm. On the basis of the information given, is it possible to compute the magnitude of the load that is necessary to produce this change in length? If so, calculate the load. If not, explain why.

Reference no: EM13559271

Questions Cloud

Estimate the diameter of the small pipe : Fluid flows steadily, at a volume rate Q, through a large pipe and then divides into two small pipes, the larger of which has an inside diameter of 25 mm and carries three times the flow of the smaller pipe.

What is the change in its linear momentum : A superball of mass 60g is dropped from a height of 2m . Itrebounds to a height of 1.80m. WHat is the change in its linear momentum

How much power dissipated in each bulb : a 360 ohms and 576 ohms light bulbs are connected in series.What is the total resistance? 360 + 576 = 936 Ohms , How much power dissipated in each bulb

Determine the percentage of the flow which passes through : A pipe network in the form of a cube is made with twelve identical pipes. Each pipe forms an edge of the cube. If the entire inflow and outflow occurs at two adjacent corners, determine the percentage of the flow which passes through the pipe connect..

Is it possible to compute the magnitude of the load : A brass alloy has a yield strength of 280 MPa, a tensile strength of 390 MPa, and an elastic modulus of 105 GPa. A cylindrical specimen of this alloy 12.7 mm in diameter and 250 mm long is stressed in tension and found to elongate

Determine the amount of heat loss by the system : Water flows in a circular pipe of diameter D at a depth y (

Find the temperature of the air after the compression : In a diesel engine, the piston compresses air at 301 K to a volume that is 0.0621 of the original volume, What is the temperature of the air after the compression

Determine the uniform depth in the channel : A clean-earth channel, for which n=0.020, is 6m wide and lies on a slope of 0.005236. Water flows at 30m3/s through the channel and enters a reservoir. The water depth in the channel, just before the entry to reservoir, is 3m.

Determine the speed of the cubic block down the plane when : Determine the speed of the cubic block down the plane when in equilibrium.Hence determine the total force required to pull the cubic block up the plane at the same speed.

User Account

All Pages