Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In the report, you need to present the following main aspects: • Title page with title? • Introduction and description of the technical problem. ? • Governing equations and boundary conditions. ? • Descriptions of your approach, grid generation, numerical methods, numerical ?boundary conditions, etc. ? • Input data and parameters, grid size. CFD conditions, convergence criteria used in ?the simulation. ? • Grid and computational results presented in figures. ? • Discussions of results. Numerical results should be compared with corresponding ?exact solutions, or experimental data, or published CFD results by others. Discuss your results. Make comments on the accuracy of your results and the performance of the numerical method for solving your flow problem (stability, accuracy, shock resolutions, etc.). ? • Conclusions. ? • References cited in the report, if there is any. ? • A print out of your computer program as an appendix of your report.
a straight fin of uniform cross section is fabricated from a material of thermal conductivity k 5 wmk thickness w 20
Bypass air exits at 600 m/s while combustion air exits at 1000 m/s. What is the thrust in kN of this engine?
a thin flat pate that is 0.2m by 0.2m on a side is oriented parallel to an atmospheric airstream having a velocity of
a refrigeration cycle uses refrigerant 134-a as the working fluid. the refrigerant enters the expansion valve as a
a garden hose attached with a nozzle is used to fill a 10-gallon bucket. the inner diameter of the hose is 2 cm and it
a non-flow process is carried out adiabatically. what is the change in specific internal energy of the fluid if 55000
comment on any safety hazards that might be encountered. especially, what would you anticipate if the inlet gas control valve were to malfunction and the gas space above the fuel were to reach full storage tank pressure (69bar)? the fuel tank has ..
the rotating parts of a front wheel assembly of a car have a total mass of 35 kg and are measured to be out of balance.
an adiabatic gas turbine using helium has inlet conditions 5 mpa and 500degc and outlet conditions of 50 kpa and
two carnot engines operate in a series. engine 2 uses the waste heat from engine 1. engine 1 receives 200kj at a
an adiabatic compressor is operating at steady state. the compressor takes in oxygen flowing at 10 m3s at a temperature
in a rigid chamber 30 lbm of helium is heated from 60 degrees farenhight and 30 psig to 90 degrees farenhight. if
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd