User Account

All Pages

In a series r-l-c circuit the phase angle is 400 degrees

Assignment Help Physics
Reference no: EM13644865

In a series R-L-C circuit, the phase angle is 40.0 degrees, with the source voltage leading the current. The reactance of the capacitor is 400 ohm and the resistance of the resistor is 200 ohm . The average power delivered by the source is 150 W.

a) Find the reactance of the inductor.

b) Find the rms current.

c) Find the rms voltage of the source.

Reference no: EM13644865

Questions Cloud

120 ohm resistor is in series with a 0140 h inductor and a : a 120 ohm resistor is in series with a 0.140 h inductor and a 0.500 micro f capacitor.a compute the impedance of the
What would happen to the width of the confidence intervals : a company that manufacturers coffee for use in commercial machines monitors the caffeine content in its coffee. the
A mechanical assembly consists of a rod with a bearing on : a mechanical assembly consists of a rod with a bearing on each end. the 3 parts are manufactured independently. the
A steam pipe of 120 mm outside diameter and is covered with : a steam pipe of 120 mm outside diameter and is covered with a 20 mm thick layer of calcium silicate insulation k
In a series r-l-c circuit the phase angle is 400 degrees : in a series r-l-c circuit the phase angle is 40.0 degrees with the source voltage leading the current. the reactance of
Let x be the number on the green die y be the number on the : a pair of fair 6-sided die one green one red are rolled. let x be the number on the green die y be the number on the
A 1000 kg rollercoaster moves in a vertical circular loop : a 1000 kg rollercoaster moves in a vertical circular loop of radius 10m as illustrated below. what is the magnitude of
If there were 2342 undergraduates how many of them had a : last years undergraduate distribution of gba was normally diatributed with a mean of 2.2 and a standard deviation of
At time t0 the velocity of the particle 4ms and the time : a particle is moving along a straight line and has an acceleration of kv2 ms2 where v is the velocity of the particle.

Reviews

Write a Review

Physics Questions & Answers

  What is the speed of flow at the lower level

Water is moving with a speed of 24.8 m/s through a pipe with a cross-sectional area of 3.0 cm2. What is the speed of flow at the lower level

  What is the heading of the plane with respect to the ground

You are traveling on an airplane. The velocity of the plane with respect to the air is 110 m/s due east, What is the heading of the plane with respect to the ground

  How far will the stone compress the spring

A 10.0kg stone slides down a snow-covered hill (the figure (Figure 1) ), leaving point A with a speed of 10.0m/s. How far will the stone compress the spring

  What is the mass of the second block

A 0.61 kg block is hung from and stretches a spring that is attached to the ceiling. What is the mass of the second block

  Determine how much of the ice melts

A 210 g piece of ice at 0°C is placed in 410 g of water at 22°C. The system is in a container of negligible heat capacity and is insulated from its surroundings. How much of the ice melts

  What is the angle between the transmission axes of filters

Unpolarized light is incident upon two polarization filters that do not have their transmission axes aligned. If 18% of the light passes through this combination of filters,

  How fast is the meteor moving with respect to earth

A woman on a rocket traveling at 0.35c (with respect to Earth) observes a meteor come from in front of her and pass her at 0.62c. How fast is the meteor moving with respect to Earth?

  What is the average rate at which energy is transmitted

On a workday the average decibel level of a busy street is 69 dB, with 102 cars passing a given point every minute. If the number of cars is condensed to 39 cars every minute on a weekend, what is the decibel level of street.

  What magnetic field should be used in the second generator

One generator uses a magnetic field of 0.185 T and has a coil area per turn of 0.0405 m2, What magnetic field should be used in the second generator

  Calculate the direction, magnitude and line of action

Calculate the direction, magnitude and line of action of the vertical and horizontal components of hydrostatic force acting on a surface.

  Calculate how far would it have to drop

A grinding wheel in the shape of a solid disk is 0.300 m in diameter and has a mass of 2.50 kg. How far would it have to drop in free fall to acquire the same amount of kinetic energy

  Write one completely detailed calorimetry equation

a certain mass m1 of ice initially at -5 c is placed into a perfectly isolated container along with a certain mass m2

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd