In a non-flow process there is a heat loss

Assignment Help Mechanical Engineering

Reference no: EM13706644

In a non-flow process there is a heat loss of 1055kJ and an internal energy increase of 210kJ. How much work is done and is the process an expansion or compression?

Reference no: EM13706644

Questions Cloud

Internal energy stating whether it is increase of decrease : During the compression stroke of an engine, the work done on the working substance in the engine cylinder is 75kJ/kg and the heat rejected to the surroundings is 42kJ/kg. Find the change of internal energy stating whether it is an increase of decreas..

Quantity of gas has an initial pressure : A quantity of gas has an initial pressure of 2.72MN/m^2 and a volume of 5.6dm^3(l). It is expanded according to the law PV^1.35 = C down to a pressure of 340kN/M^2. Determine the final volume and work done.

Measures a wind tunnels velocity n times : During an experiment, an aerospace engineering student measures a wind tunnel's velocity N times. The student reports the following information, based on 90% confidence, about the finite data set: mean velocity=25 m/s, velocity standard deviation=1.5..

Determine the new volume of the gas : 0.112m^3 of gas has a pressure of 138kN/m^2. It is compressed to 690kN/m^2 according to the law PV^1.4 = C. Determine the new volume of the gas.

In a non-flow process there is a heat loss : In a non-flow process there is a heat loss of 1055kJ and an internal energy increase of 210kJ. How much work is done and is the process an expansion or compression?

Air passes through a gas turbine system : Air passes through a gas turbine system at a rate of 4.5kg/s. It enters with a velocity of 150m/s and a specific enthalpy of 3000kJ/kg. At exit, the velocity is 120m/s and the specific enthalpy is 2300kJ/kg. The air has a heat loss to the surrounding..

Find the specific gravity of the material : A cube of material is 4 in. on a side and floats at the interface between kerosene and water, as shown in the figure. Find the specific gravity of the material.

Determine the stress-strain-youngs modulus : A steel rod of radius 0.01 m and length 2. M is pulled on with a tensile force of 200,000 N, and the bar stretches to a length of 2.08 m. The radius of the bar is reduced to 0.0099 m. Determine the stress, strain, Young's modulus (E), and Poisson's r..

Manufacturer claims the average velocity of air leaving fan : A fan with a diameter of 12 inches operates at a voltage of 120V with a current draw of 0.5 amps. The manufacturer claims the average velocity of air leaving the fan is 33.1 ft./s under standard conditions. Standard air has a density of 0.075 lb mass..

User Account

All Pages