Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The source has an abc-phase sequence. At the wye-connected load, the phase-a voltage Va'n' has phase angle (theta)a'n' = 60 degrees and the phase impedance is (10 + j15) ohms. Further, the line impedance per phase is (1.1+ j1.5) ohms and the total power loss in the three lines is 480 W.
(a) Draw a well-labeled diagram to illustrate the per-phase analysis of the power transmission system.(b) Determine the complete set of phase voltages at the wye-connected source.
A ‘c-core' inductor has a total air-gap length of 3 mm and a cross-sectional area of 100 cm2. Two coils are wound on the core - one of 500-turns and another of 250-turns. Assuming the iron reluctance, fringing flux and leakage flux to be negligibl..
A 60-Hz, single phase source with V= 277 at angle 30 degree volts is applied to a circuit element. Determine the instanaeous power, real power, and reactive power absorbed by determine the source power factor and state lagging or leading.
Calculate the minimum value of Vd if the power flow through the converter is 5 kW (a) from the ac to the dc side and (b) from the dc to the ac side.
A 300 V, 60 A, 1200 rpm series dc motor has an armature and series field resistance of .2 ohms each. When a .10 ohm resistance is connected in parallel to the winding, the motor's torque is doubled.
A ideal transformer is rated at 4800/480 volt, at 75KVA. it is connected as a step down auto transformer. find the line and load voltages, turns ratio and total apparent, real and reactive power at full load and at 60% rated load at a power factor..
An 8cm diameter hydraulic cylinder has a 4cm diameter rod. If the cylinder receives flow at 100Lpm and 12MPa, find the a) Extension and retraction speeds b) Extension and retraction load-carrying capacities
Draw the positive, negative, and zero sequence networks for the system. Include all impedance values and determine the bus voltages at midnight? What problem(s) do you detect?
what sources to pick to get total absorbed power and total delivered power, since a,e,f, and h absorb and b,c,d,and g supply and for total they suggest a+c+d+e+c=absorbed and b+g+f=delivered
SR flip flop from D Flip flops, Show how to build a rising edge triggered SR flip-flop using a rising edge triggered D flip-flop and combinational logic.
generated by a loud speaker is reflected at two different walls with reflection coefficients r1 and r2. the signal x(t) recorded by amicrophone close to the loud speaker, after sampling is
(b) Calculate the power dissipated in the MOSFET when the lamp is operating at its rated current. (c) The maximum output current available from the logic system is 30mA. Explain why an NPN transistor would be unsuitable for this appli..
How a transformer works and apply those rules to a transformer where the primary core cross-sectional area is twice.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd