If the process is adiabatic and internally reversible

Assignment Help Mechanical Engineering
Reference no: EM13639216

Steam enters a turbine at 600 psia, 900°F, and 250 ft/s. It expands through a pressure ratio of 10:1 (i.e. to 60 psia) and leaves the turbine at a velocity of 500 ft/s.

a) If the process is adiabatic and internally reversible, calculate the work output per pound of steam. Be sure to account for changes in kinetic energy across the turbine.

b) Now consider the case where the internal irreversibilities reduce the work output to 85 percent of the reversible case. For the same pressure ratio, find the final temperature and final specific entropy.

 

Reference no: EM13639216

Questions Cloud

If the diameter of the second pipe is also 3 inches at what : a tank has an inlet flow with a velocity of 200 ftmin through a 4 inch diameter pipe. the fluid is water at standard
What is the acceleration of an electron that is placed in a : what is the acceleration of an electron that is placed in a uniform electric field of 5600 nc pointing in the
What is the minimum pressure in kpa that must be applied at : what is the minimum pressure in kpa that must be applied at 25 degc to obtain pure water by reverse osmosis from water
A large plane having uniform charge density has an : a large plane having uniform charge density has an electric field just outside the plane that points directly toward
If the process is adiabatic and internally reversible : steam enters a turbine at 600 psia 900degf and 250 fts. it expands through a pressure ratio of 101 i.e. to 60 psia and
Two positive point charges each 16 uc lie along the x-axis : two positive point charges each 16 uc lie along the x-axis at x -0.12m and x 0.12m.a. find the electric field at the
An ice cube that is 2500 g temp -20 c is placed into 22500 : an ice cube that is 25.00 g temp -20 c is placed into 225.00 g of h2o that is 22 degrees c. what will the temperature
An electron and a proton are each accelerated through a : an electron and a proton are each accelerated through a potential difference of 21 million volts. find the momentum in
A researcher wants to test the association between number : a researcher wants to test the association between number of speeding tickets issued and type of car model. a 4 x 5

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The sphere approaches the 25 degree incline of height 3 m

a large sphere i25mr2 rolls without slipping pure rolling across a horizontal surface. the sphere has a constant

  Solid carbon reacts with steam to produce carbon monoxide

solid carbon reacts with steam to produce carbon monoxide and hydrogen. given an hc atom ratio of 11 and an oc atom

  A communication satellite weighing 10000 lb including fuel

a communication satellite weighing 10000 lb including fuel has been ejected from a space shuttle describing a low

  A round casting is 01 m in diameter and 5 m in length what

a round casting is 0.1 m in diameter and .5 m in length. another casting of the same metal is elliptical in

  The axis of rotation is through the center of the round

an external moment of 500 n-m is applied to the composite plate in clockwise direction as shown. the square plate is

  Due to the elasticity of the balloon the pressure remains

a spherical balloon filled with heliumm is initially at 300 k and 100 kpa with a diameter of 5 cm. the balloon is

  A horizontal axisymmetric jet of air with 10 mm diameter

a horizontal axisymmetric jet of air with 10 mm diameter strikes a stationary vertical disk of 200 mm diameter. the jet

  A solar hot water heater raises the temperature of 200

a solar hot water heater raises the temperature of 200 liters of water from 27 to 47 degrees c. suppose a heat engine

  If the total flow rate of gas out of the stack is 190

a stack was sampled for 8 minutes. the gas velocity at stack conditions through the sampler was 15.0 ms and the area

  What value of sp is required

In a tubular low pressure chemical vapor deposition (LPCVD) reactor, gas is introduced at one end at a rate of 75 torr-L/min. At the other end is a vacuum pump of a speed Sp. If the reactor must operate at 1 torr, what value of Sp is required?

  Water steam at 3mpa and 400oc is expanded to 100kpa in an

water steam at 3mpa and 400oc is expanded to 100kpa in an adiabatic turbine with an isentropic efficiency of 92.

  A 45 wt pb-55 mg alloy is rapidly quenched to room

a 45 wt pb-55 mg alloy is rapidly quenched to room temperature from an elevated temperature in such a way that the high

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd