Identifies nesess new network requirements

Assignment Help Computer Networking

Reference no: EM13557770

Part 1 - Report

You are asked to produce a report that identifies NESES's new network requirements. You should suggest a network solution that demonstrates the appropriateness and suitability of your design. Whilst outlining reasons for your preferred solution you should identify your choice of equipment & protocol.

You should ensure that design is in line with current design models and you should clear show how your networks design maps to it. You can assume that all internet connectivity is via one centrally managed point, however any remote access will be local to that service.

Part 2 - Practical

Using Packet Tracer you should build your preferred solution to demonstrate both the required functionally and fault tolerance to the Group Management Team.

You should configure all virtual devices as per your preferred solution and be able to demonstrate the required functionality and fault tolerance.

As you may not be the consultant who will perform the network upgrade for NESES you must ensure that all devices and connections are correctly specified, labelled and configured.

Part 3 - Analysis

Using Riverbed Modeler, you should run simulations on your network design to identify any bottlenecks and points of failure with your network design, and you will need to show empirical evidence for the minimum link speed requirements between all nodes.

Reference no: EM13557770

Questions Cloud

State the vapor pressure of pure ethanol : What mass of should be added to 630 of the paraffin in formulating the mixture if the vapor pressure of ethanol at 35 over the mixture is to be 9. The vapor pressure of pure ethanol at 35 is 100.

Find where is the center of mass of the slab : half of a slab is made of aluminum (density = 2.70 g/cm^3) andits length is 11.0cm, its width - 13.0 cm, and its height - 2.80cm;the other half of the slab is made of iron (density = 7.85g/cm^3), Where is the center of mass of the slab

Explain the average mass of an atom of sulfur : The average mass of an atom of sulfur is 5.33 X 10-23 g. How many sulfur atoms are present in a 100.0g sample of sulfur

Find where is the center of the assembly : Three thin rods each of length L are arranged in invertedU. The two rods on the arms of the u each have mass M; Where is the center of the assembly

Identifies nesess new network requirements : You are asked to produce a report that identifies NESES's new network requirements. You should suggest a network solution that demonstrates the appropriateness and suitability of your design.

Explain the molarity of a solution prepared by kbr solution : What is the molarity of a solution that was prepared by adding 100ml of 0.225M KBr solution to 500ml of water

Find what is the largest size vehicle it can lift : The maximum gauge pressure in a hydraulic lift is 17.0 atm. What is the largest size vehicle(kg) it can lift if the diameter ofthe output line i9s 28.0cm

What is the acceleration of the center of mass of the ball : A Ball Rolling Uphill. A bowling ball rolls without slippingup a ramp that slopes upward at an angle beta to the horizontal. What is the acceleration of the center of mass of the ball

Explain what are the total number of protons and electrons : How many electrons has a titanium atom lose if it has formed the ion Ti^4+. What are the total number of protons and electrons in a Ti^4+ ion

User Account

All Pages