Hydrostatics and stability-lightship condition

Assignment Help Mechanical Engineering

Reference no: EM13701671

Hydrostatics and stability

In lightship condition, how does the ship trim and why?

How does the ship react when weights are added or subtracted?

How does the curve of statical stability change with vertical shift of weights?

How does the curve of statical stability change with horizontal shift of weights?

A ship trims about which point? How is it calculated?

What are floundering and capsizing? Which is more likely? Why?

What are the 6 degrees of freedom?

Which are the DOF motions visible in sheer plan?

Which are the DOF motions visible in body plan?

Reference no: EM13701671

Questions Cloud

Suppose an object moves on a horizontal line : Suppose an object moves on a horizontal line. If the object starts from rest at the origin and it has an acceleration of 16t-t, Determine the total distance the object has moved when time is 2 seconds. Note the distance moved is not the position. For..

Determine total and flow energies of the steam per unit mass : Steam is leaving a pressure cooker whose operating pressure is 30 psia. It is observed that the amount of liquid in the cooker has decreased by 0.45 gal in 60 minutes after the steady operating conditions are established, and the cross-sectional area..

Calculate the interface pressure at the lx-10 interface : How long in time must the pressure pulse be to allow for a detonation to occur and what is the minimum distance that the shock must traverse to allow for a detonation to occur?

Vertical at the opposite tip of the first triangle : Determine the force in each member below by using the methods of joints. one force is 4kN at 30 degrees at the tip of the first triangle, and another 3kN force is vertical at the opposite tip of the first triangle.. There are 8 members composed of 4 ..

Hydrostatics and stability-lightship condition : Hydrostatics and stability-In lightship condition, how does the ship trim and why? How does the ship react when weights are added or subtracted? How does the curve of statical stability change with vertical shift of weights?

Determine the systems thermal efficiency : Air enters a three-stage gas turbine at 100 kPa and 17 degree Celsius. This system uses a regenerator as well as reheating and inters cooling. The pressure ratio across each compressor is 14.16 (this is 14.16, NOT 14 and 16!); 300 kJ/kg of heat are a..

Domestic hot water supply : Steam at 500 kPa, 300 degrees C is used to heat cold water at 15 degrees C to 75 C for a domestic hot water supply. How much steam per kilogram of liquid water is needed if the steam should not condense?

Determine the response of the measurement system : A measurement system can be modelled by the equation given below, (5/8)y' +y=F(t). The output signal is initially steady at 5 V. The input signal is then suddenly increased to 8 V. Determine the response of the measurement system.

The two purposes of amplification for digital systems : The two purposes of amplification for digital systems are (i) to improve signal-to-noise ratio and (ii) to make good use of the dynamic range of the digitizer; in other words, to ensure the best resolution possible.

User Account

All Pages