Hydraulic radius of the river

Assignment Help Civil Engineering
Reference no: EM1385344

The White River in Vermont (USA) has a rectangular channel cross-section with a Manning coefficient is n = 0.040 and the downstream bed slope is S = 5.0 × 10-5. In the summer, the width of the river and the center water depth are, respectively, 9.8 m and 1.2 m.

a) In that season, what are the hydraulic radius of the river, its mean velocity and volumetric discharge?

Reference no: EM1385344

Questions Cloud

Objective questions based on biology : At room temperature, equilibrium potential of K+ in a cell with internal concentration of K+ 10 fold higher than that of external concentration will be approximately.
Unsupervised actions of the bank president : Can Rodale be held liable to the bank for losses resulting from the unsupervised actions of the bank president and the loan committee.
What are the minimum number of servers required : customers per hour and an average service time of 18 minutes per customer. What are the minimum number of servers required to avoid an overloaded system?
What is the length of driveway : A flywheel having constant angular acceleration requires 4.6-{rm s} to rotate through 162 rad. Its angular velocity at the end of this time is 100 rad/s. Find out the angular velocity at the beginning of the 4.6s interval; the angular acceleration..
Hydraulic radius of the river : In that season, what are the hydraulic radius of the river, its mean velocity and volumetric discharge?
What is the system utilization : A single bay car wash with a Poisson arrival rate and an exponential service time has cars arriving an average of 10 minutes apart, and an average service time of four minutes.
Joel is displeased with his son lifestyle choices : May disinherit his son for any reason as long as Joel indicates in the will which the son was omitted on purpose. May disinherit his son only if Joel leaves the son a nominal amount, such as $1.
What is the final temperature of gas : Two simple pendulums have length of 81-cm and 64-cm they are released from the same angular position at the same instant. After how much time would they both arrive at their initial position simultaneously.
Calculating the principle of shoring system : How to calculate the principle of shoring system in formwork analysis when the secondly floor upper has been poured?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Write a report on toxic and hazardous waste

Toxic and Hazardous waste: how are they treated, safety measures, regulations in USA about hazardous waste.

  Elastic modulus of steel

Given: elastic modulus of steel is 200 GPa, yield and ultimate tensile strength of steel are 600 and 750 MPa, respectively.

  Minimizing the tension tab

What should TAC , TAB and the acute angle ? between TAB and the vertical to minimize the tension TAB ? Take o and W = 1,000 N. Hint: Consider various possible force triangles and decide on inspection how to minimize TAB.

  Commercial management in civil engineering

Devise a appropriate management system that you as a commercial manager for the contractor would recommend to the project team for use on a construction or building contract.

  Mass flow raw through the nozzle

Air enters an adiabatic nozzle steadily at 300 kPa, 200 o C, and 30 m/s and leaves at 100 kPa and 180 m/s. The inlet area of the nozzle is 80 cm 2 . Determine (a) the mass flow raw through the nozzle, (b) the exit temperature of the air, and (c) the ..

  Calculate the molar mass of the biomolecule

A 2.50-g sample of a large biomolecule was dissolved in 13.0 g of carbon tetrachloride. The boiling point of this solution was determined to be 77.85°C. Calculate the molar mass of the biomolecule.

  Arrival of vehicles according to a poisson process

At a specified point on a highway, vehicles are known to arrive according to a Poisson process. Vehicles are counted in 20-second intervals, and vehicle counts are taken in 120 of these time intervals.

  Determining pressure in a coal mining dragline

The total flow then moves to a point W on the traction drive two metres off the ground, and travels through a nine millimetre diameter conduit. Ignoring all friction and minor losses, determine the pressures at points H and W.

  Force exerted by the hydraulic cylinder

The gate is rectangular with a horizontal width of 2m perpendicular to the paper. For a depth h = 3m of water, calculate the required force exerted by the hydraulic cylinder to keep the gate just closed.

  Fraction of the herbicide

The herbicide 2,4,D, is applied to a golf course at a rate of 1.2 kg/ha. The organic matter content of the soil is 1%, bulk density is 1.3 g/cm3, and water content is 0.3. a) What fraction of the herbicide is adsorbed, and what fraction is dissolve..

  Determine the flow rate of the oil

Oil of a specific gravity of 0.75 is flowing through a 6-in pipe under a pressure of 15 psi. If the total energy relative to the datumplate is 8.0 ft below the center of the pipe is 58.6 ft, determine the flow rate of the oil.

  Parabolic trajectory of the falling prey

A hawk flying at 2 m/s at an altitude of 45 m accidentally drops its prey. The parabolic trajectory of the falling prey is described by the equation below until it hits the ground, where y is its height above the ground and x is its horizontal dis..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd