How to label turing points numerically starting with tp1

Assignment Help Civil Engineering
Reference no: EM13296977

A differential leveling loop started and closed on BM Juno, elevation 5194.02 ft. The BS and FS distancces were kept approximately equal. Readings (in ft) listed in the order takken are 9.65, 2.11, 2.51, 8.35, 2.06, 9.25, 7.93, 2.83, 5.05, and 4.61. Prepare, check and adjust the notes. Label turing points numerically starting with TP1

Reference no: EM13296977

Questions Cloud

Which topological space that we have previously encountered : Which topological space that we have previously encountered appears to be topologically equivalent to the quotient space that results from this partition?
Design a curve for the highway by computing the radius : The PI is at station 250+50, the design speed is 65mi/h, and a maximum superelevation of 0.07 ft/ft is to be used. If the central angle of the curve is 38 degrees, design a curve for the highway by computing the radius and stationing of PC and PT.
How far stream of section would expect to find uniform flow : The slope of the channel is .15% and the mannings roughness coefficient is .038. estimate the depth 100m upstream of a section where the flow depth is 2.2m using the standard step method. Approximate how far upstream of this section would you exp..
What yield on the chicago municipal bonds would make : If Treasury bonds yield 6%, and Carter's marginal income tax rate is 40%, what yield on the Chicago municipal bonds would make Carter's treasurer indifferent between the two? Answer 3.42% 3.60% 3.78% 3.97% 4.17%
How to label turing points numerically starting with tp1 : A differential leveling loop started and closed on BM Juno, elevation 5194.02 ft. The BS and FS distancces were kept approximately equal. Readings (in ft) listed in the order takken are 9.65, 2.11, 2.51, 8.35, 2.06, 9.25, 7.93, 2.83, 5.05, and 4.6..
Obtain the change in the internal energy of the gas : Three moles of an ideal monatomic gas are at a temperature of 345 K.  What is the change in the internal energy of the gas
Calculate the internal rate of return for each alternative : The company's tax rate is 50 percent, and its cost of capital is 11 percent. Calculate the internal rate of return for each alternative.
Determine the specific gravity of barge runs on diesel fuel : a poorly designed 100 ft long homogeneous barge runs on diesel fuel, the fuel is held in a 2' tall trapezoidal tank of the same length as the barge. and is located at the bottom of the barge hull.
Design a horizontal curve with a 40-degree central angle : Design a horizontal curve with a 40-degree central angle (delta=40) for a two-lane road with 11-ft lanes. The design speed is 70 mi/h and superelevation is limited to 0.06ft/ft. Give radius, degree of curvature, and length of curve

Reviews

Write a Review

Civil Engineering Questions & Answers

  How do the crack behaves under the compression

how do the crack behaves under the compression of a concrete cubes under friction between the plates and specimen with stress strain diagram?

  What are the factors affecting the hydraulic conductivity

what are the factors affecting the hydraulic conductivity?

  Comparative analysis of the types of safeguards

Provide a comparative analysis of the types of safeguards would you suggest for the company's information system.

  Measure the distance pa, pb, pc

Measure the distance PA, PB, PC etc. from p to various point with chain or tape and plot them to scale along the co responding rays. Join the points a, b, c, etc. to give outline of survey.

  What will be the shear stress

A trapezoidal channel is carrying water at a normal depth of 5.2 ft, the channel has a bottom width of 10 ft and side slopes of 2 H to 1 V. It is running on a slope of 0.005 ft/ft. What will be the shear stress in lb/ft^2 exerted on the channel be..

  What is the level of the service of this compound-grade

If the peak-hour factor is .90 and all of the drivers are regular users, what is the level of the service of this compound-grade freeway segment?

  Determining axial load of a dense sand

A dense sand has an effective friction angle of 43 and c'=0. A dry, 2.8-inch diameter sample is tested in drained triaxial shear with a confining pressure of 2500 psf. What axial load, P (in pounds), will be required to fail the sample?

  Qualitative or quantitative risk assessment on the project

Conduct either a qualitative or quantitative risk assessment on this project. Identify the risk factors that you consider most important for the suspension bridge construction. How would you assess the riskiness of the project? Why?

  Internal element of compression flange

what do mean by outstand element of compression flange, internal element of compression flange and web general

  Overall gear reduction ratio

If the overall gear reduction ratio is 8 to 1, what is the maximum acceleration from rest (in ft/sec^2) for: a) the car with the base engine? b) car with the modified engine? Assume the car is on good dry pavement.

  Change in it internal energy

A gas is compressed at a constant pressure of 0.800 atm from 9.00L tp 2.00L. in the process, 400J of energy leave the gas by heat. (a) What is the work done on the gas? (b) What is the change in it internal energy?

  Enforcement team investigating possible dumping of arsenic

Suppose you are a member of an EPA enforcement team investigating the possible dumping of arsenic into Arbor Lake. You take water samples from the middle of the lake and find that the concentration is 90.0 ppb.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd