How to get the intensity of the rainfall from information

Assignment Help Civil Engineering

Reference no: EM13544581

1.For a hydrology question we are given the depth of runoff and the time. We are to make a hyetograph using this information but Im not sure how to get the intensity of the rainfall from this information

2.A couple M of magnitude 18N*m is applied to the handle of a screwdriver to tighten a screw into a block of wood. Determine the magnitudes of the two smallest horizontal forces that are equivalent to M if they are applied a) at corners A and D, b) at corners B and C, c) anywhere on the block

Reference no: EM13544581

Questions Cloud

Determine the total amount of heat transfer from the : Liquid propane is commonly used as a fuel for heating homes, powering vehicles such as forklifts, and filling portable picnic tanks. Consider a propane tank that initially contains

Determine the rate of ammonia nh4-n utilization and the : Determine the rate of ammonia (NH4-N) utilization and the biomass growth rate for the following conditions:

Estimate the annual et losses in inches for the area : For a drainage area of 5,187mil^2 mean annual runoff is determined to be 3,708ft^3/s and the annual averge rainfall is 35.5 inches. Estimate the annual ET losses in inches for the area. ( 1 mile = 5,280ft)

What is the recommended clear zone distance : What is the recommended clear zone distance for the following roadway situations? (Use the Clear Zone nomograph to find solutions)

How to get the intensity of the rainfall from information : For a hydrology question we are given the depth of runoff and the time. We are to make a hyetograph using this information but Im not sure how to get the intensity of the rainfall from this information

What would the concentration in the effluent be 7 days later : A lagoon with volume 1200 m3 has been receiving a steady flow of a conservative waste at a rate of 100 m3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10 mg/L. Assuming ..

What is the minimum possible value for this pressure : Part of a vertical piping system consists of 8 ft of 4 in diameter, connected to 8 ft of 3 in diameter above, and connected to 8 ft of 2 in diameter above that. Water at 60 F flows up the pipe (no downward flow occurs)

What pressure must be provided at point 1 if you neglect : A pressure gage at elevation 4.8 m on the side of a storage tank containing oil reads 34.7 kPa.Another gage at elevation 2.2 m reads 57.5 kPa. Compute the specific weight, density, and specific gravity of the oil.

Find the steady-state concentration if the air is assumed to : Consider the air over a city to be a box 100 km on a side that reaches up to an altitude of 1.0 km. Clean air is blowing into the box along one of its sides with a speed of 4 m/s.

User Account

All Pages