How to evaluate the ph of the solution

Assignment Help Chemistry
Reference no: EM13294603

1.00 mol HF and 0.500 mol NaOH are both dissolved in water making 1.00L solution. Calculate the pH of the solution?

Reference no: EM13294603

Questions Cloud

Find the average horizontal force the wall exerts on ball : You throw a ball with mass 0.40 kg against a brick wall. It hits the wall moving horizontally to the left at 30. m/s, find the average horizontal force the wall exerts on the ball during the impact
Explain the same mechanism as the trans acid : What product or products would you expect to obtain by the addition of bromine to cis-cinnamic acid, assuming that it reacts by the same mechanism as the trans acid
Build a 4-to-1 mux using tri-state buffers and two inverter : Build a 4-to-1 MUX using some tri-state buffers and two inverters(NOT gates). (Hint: you can build a 2-to-1 MUX using some tri-statebuffers and one inverter and then combine several 2-to-1 MUXes tobuild a 4-to-1 MUX.)
Compute the pearson correlation : What are the Sum of Squares between (SSB) and what is the degress of freedom within (dfW)
How to evaluate the ph of the solution : 1.00 mol HF and 0.500 mol NaOH are both dissolved in water making 1.00L solution. Calculate the pH of the solution
Find the emf in one turn of the solenoids windings : A 1.50-m-diameter MRI solenoid with a length of 2.20m has a magnetic field of 1.60T along its axis. find the emf in one turn of the solenoid's windings
What is the weighted average cost of the added funds : What is Nealon's cost of equity capital when new shares are sold, and what is the weighted average cost of the added funds involved in the issuance of new shares?
Estimate the temperature coefficient of resistivity : A coil of wire has a resistance of 38.0 ? at 25° C and 43.7 ? at 56° C. What is the temperature coefficient of resistivity
How large can roll off factor be for the allowable system : what is the theoretical minimum system bandwidth needed for a10Mbits/sec signal using 16-level PAM without inter sysmbol interference how large can the roll off factor be if the allowable system bandwidth is 1.375 MHz.

Reviews

Write a Review

Chemistry Questions & Answers

  State what concentration of hi is present at equilibrium

At a certain temperature, the equilibrium constant, Kc, for this reaction is 53.3.at this temperature, 0.400 mol of H2 and 0.400 mol of I2 were placed in a 1.00-L container to react. What concentration of HI is present at equilibrium

  Compute the fractional conversion of the limiting reactant

The feed to reactor contains only C 2 H 4 and HBr. if the molar flow rate = 165mol/s, compute the fractional conversion of the limiting reactant?

  Find the empirical formula

A compound is found to be 74.03% C, 8.70% H, and 17.27% N. The molar mass of the compound is 162.23 g/mol. Find the empirical formula and the molecular formula of the compound?

  Compute the initial percent dissociation of the acidsample

You found that pH=pKa=4.2 when 12.50 mL of NaOH hadbeen added. The concentration of the sodium hydroxide was 0.500M. Calculate the initial percent dissociation of the acidsample.

  Calculate the heat of enthalpy for the reaction

Calculate the heat of enthalpy for the reaction: PCl5(g) → PCl3(g) + Cl2(g)

  P-nitrobenzaldehyde in the aldol reaction

The yield of the reaction to form your chalcone is not quantitative. What side products might be formed from your aldol condensation?

  Find out qc if the following amounts of each component

Determine Qc if the following amounts (in moles) of each component is placed in a 10.00 L container.

  Determine the equilibrium concentrations of the gases

For the equilibrium  2H2S(g) 2H2(g)+S2(g) Kc=9.0x10^-8 at 700 degrees C. The initial concentrations of the three gases are 0.550 M H2S, .550 M H2, and .275 M S2. Determine the equilibrium concentrations of the gases.

  Explain what is the protein concentration of the original

The absorbance at 595 was 0.75 and according to a BSA standard curve corresponding to 0.025 mg protein on the x-axis. What is the protein concentration (mg/ml) of the original protein?

  How much oxygen gas is needed

Consider the reaction 4 Fe(s) + 3 O2(g) → 2 Fe2O3(s). If 12.5 g of iron(III) oxide (rust) are produced from 8.74 g of iron, how much oxygen gas is needed for this reaction?

  Compute the mass percent for the solute

Calculate the mass percent (m/m) for the solute in each of the following solutions: Express the answer using 2 sig figures.

  State sodium benzoate should be added to prepare the buffer

how many grams of sodium benzoate should be added to prepare the buffer?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd