How to calculate ph for the reaction

Assignment Help Chemistry
Reference no: EM13276366

The burning of 80.3 g of SiH4 at constant pressure gives off 3790 kJ of heat. Calculate ?H for this reaction.

Reference no: EM13276366

Questions Cloud

Calculate the total current flowing through the battery : Consider a circuit with two resistors in parallel; R1=10 Ohm and R2=5 Ohm, Calculate the total current flowing through the battery
Explain how much heat energy is liberated : How much heat energy is liberated when 11.0 grams of manganese is used in the formation of Mn2O3. PHf° for Mn2O3 is -962.3 kJ/mol
Calculate the cost of energy for the period 1947 to 1994 : Construction on Hoover Dam was started in 1931 and finished in 1935, and the dam was in service from 1936. When completed, it was both the world's largest electric power producing facility and the world's largest concrete structure.
Find the power output from the power supply : A 31 μF capacitor is connected across a programmed power supply. find the power output from the power supply
How to calculate ph for the reaction : The burning of 80.3 g of SiH4 at constant pressure gives off 3790 kJ of heat. Calculate ?H for this reaction.
Find the power being absorbed by the resistor and inductor : A current source, Is =16.5cos(2300t) A, a resistor R=134Ω, and an inductor, L=0.12H are all in parallel. Assume steady-state conditions exist. At t=3.9ms, find the power being absorbed by the a.)resistor, b.)inductor, c.) sinsuoidal source
Determine the coil resistance : Two scales on a voltmeter measure voltages up to 21.0 and 30.7 V, respectively. Determine the coil resistance
Find the input power in kw and the efficiency in percent : A 440 Vrms (line to line voltage) three phase induction motor runs at 1150 rpm driving a load requiring 15Nm of torque. The line current is 3.4 at a power factor of 80% lagging. Find the input power in Kw, The output power in Kw, and the efficiency..
Explain what is the ph of a tris buffer : what is the pH of a Tris buffer (pka 8.1) prepared by adding 20 mL of 1M HCl to 100mL of a solution of 0.3M Tris

Reviews

Write a Review

Chemistry Questions & Answers

  Define what are the equilibrium pressures of n2o4

What are the equilibrium pressures of N2O4 and NO2 when 0.61 mol of each gas are introduced

  State transition metal complex with the formula

Five potential structures belonging to point groups Oh,D3h,D6h,D2h and D3d. Sketch geometries that are consistent with the possible point groups?

  What is the percent hydrogen (h) by weight

What is the percent hydrogen (H) by weight of a solution containing 53.5 mL of CH3COCH3? The density of acetone is 0.788 g/mL.

  Define ph halfway to the equivalence point for the titration

What is the pH halfway to the equivalence point for the titration of 0.20 M CH3NH2 with 0.20 M HCl? (Kb of CH3NH2 = 4.4 x 10-4)

  Compute the mass percent for the solute

Calculate the mass percent (m/m) for the solute in each of the following solutions: Express the answer using 2 sig figures.

  Define how many seconds after the start of the reaction

How many seconds after the start of the reaction does it take for the reactant concentration to decrease to 0.0185 M?

  Find out the number of mols of hydrogen in the compound

the reaction produces 0.90 mol of CO2 and 0.45 mol of H2O. Determine the number of mols of carbon in the compound. Determine the number of mols of hydrogen in the compound.

  State what is the concentration of fe

A solution is made by mixing 4.6 mL of 0.274 M Fe(NO3)3 and 656.0 mL of water. What is the concentration of Fe3+ in the resulting solution?

  Explain what is the maximum strength of acetic acid waste

What is the maximum strength of acetic acid waste ( as TOC in mg/L) that can be discharged without violating either permit requirement. ( recall that TOC in mg/L , measures the number of miligrams of carbon per liter)

  What is the normal boiling point

The vapor pressure of chlorine dioxide (ClO2 )  is 155 Torr at -22.75  ? C and 485 Torr at  0 ? C. What is the normal boiling point of  chlorine dioxide?

  State the crossed aldol condensation of acetaldehyde

The crossed aldol condensation of acetaldehyde with benzaldehyde is aided by the fact that benzaldehyde bears no α-protons. However, a possible competitive reaction is the “selfcondensation†of two molecules of acetaldehyde.

  How much heat is required

How much heat is required to convert 27.0 grams of ethanol at 28 degrees celcius to the vapor phase at 78 degrees celcius?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd