How much work was required to pull the plates

Assignment Help Physics
Reference no: EM13700400

Solve the all parts of following question given below:

Question: A parallel-plate capacitor has plates, each with an area of 4.0 cm2, that are separated by a distance of 0.30 mm. The capacitor is first is connected to a 12 V battery, and fully charged. For parts (a) through (d) below, the battery is then disconnected.

Part I: What is the charge on the capacitor?

Part II: If the plates are then pulled to a separation of 0.80 mm, what is the charge on the capacitor now?

Part III: What is the potential difference across the plates now?

Part IV: How much work was required to pull the plates to their new separation?

Part V: Now go back to the first part of the problem with the capacitor connected to the battery and plate separation 0.30 mm. If the capacitor stays connected to the battery and the plates are pulled apart to a separation of 0.80 mm, what is the new potential difference across the capacitor?

Part VI: For the situation in part (e), what will be the new charge on the capacitor?

Any help I can get on this question is greatly appreciated! I'm not too familiar with this question.

Reference no: EM13700400

Questions Cloud

What is the maximum height the ball goes above the ground : Julie throws a ball to her friend Sarah. The ball leaves Julie's hand a distance 1.5 meters above the ground with an initial speed of 12 m/s at an angle 49 degrees; What is the maximum height the ball goes above the ground
Valid confidence interval : Valid Confidence Interval: A pollster for the Gallup Organization randomly generates the last two digits of telephone numbers to be called, so the numbers from 00 to 99 are all equally likely. Can the methods of this section be used to constru..
What must be the initial speed of the first ball : A ball is thrown straight up from the edge of the roof of a building. A second ball is dropped from the roof 1.00 seconds later , what must be the initial speed of the first ball
How far north the kayak has traveled : A kayak on a lake is moving at a constant speed of 3.0 m/s in a direction 41.9° north of west. After 30 min, How far north the kayak has traveled
How much work was required to pull the plates : A parallel-plate capacitor has plates, each with an area of 4.0 cm2, that are separated by a distance of 0.30 mm. How much work was required to pull the plates
How long does it take the red ball to reach the ground : A red ball is thrown down with an initial speed of 1.1 m/s from a height of 28 meters above the ground. How long does it take the red ball to reach the ground
Determine the rms voltage across it : An electrical device uses 1600 W of power when the amplitude of the alternating current is 3.5 A. What is the rms voltage across it
Estimate how long is the string : A string vibrates at its third-harmonic frequency. The amplitude at a point 33cm from one end is half the maximum amplitude. How long is the string
How long after the blue ball is thrown are the two balls : A blue ball is thrown upward with an initial speed of 24.1 m/s, from a height of 0.8 meters above the ground. 2.9 seconds after the blue ball is thrown, How long after the blue ball is thrown are the two balls

Reviews

Write a Review

Physics Questions & Answers

  Find the magnitude of the resulting magnetic field

A sphere of radius R is uniformly charged to a total charge of Q. It is made to spin about an axis that passes through its center with an angular speed ω. Find the magnitude of the resulting magnetic field at the center of the sphere.

  Find the equivalent resistance

A resistor is in the shape of a cube, with each side of resistance  R . Find the equivalent resistance between any two of its adjacent corners.

  What is the electric field at the location

Question: Field and force with three charges? What is the electric field at the location of Q1, due to  Q 2 ?

  What is the maximum displacement of the bridge deck

What is the maximum displacement of the bridge deck?

  What is the magnitude of the current in the wire

What is the magnitude of the current in the wire as a function of time?

  Blackbody

Questions on blackbody, Infra-Red Detectors & Optic Lens and Digital Image.

  Gravity conveyor

Illustrate the cause of the components accelerating from rest down the conveyor.

  Calculate the dc voltage

Calculate the dc voltage applied to the circuit.

  Quadrupole moments in the shell model

Quadrupole moments in the shell model

  Determine the tension in each string

Determine the tension in each string

  Introductory mechanics: dynamics

Calculate the smallest coefficient of static friction necessary for mass A to remain stationary.

  Evaluate maximum altitude

Evaluate maximum altitude?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd