How much work is done on the canister

Reference no: EM13713255

Find the correct solution for the certain problem

Problem- The only force acting on a 4.2 kg canister that is moving in an xy plane has a magnitude of 5.3 N. The canister initially has a velocity of 4.7 m/s in the positive x direction, and some time later has a velocity of 6.4 m/s in the positive y direction.

Part 1- How much work is done on the canister by the 5.3 N forces during this time?

You need to calculate the answer of the above problem.

Reference no: EM13713255

Questions Cloud

Resonance occur for an unhampered spring-mass system : For what value of m will resonance occur for an unhampered spring-mass system with spring constant k at 3x10^5 N/m under a harmonic excitation f(t)=200sin(50t)?

Abrasive machining-honing-lapping and surface grinding : Define and identify unique characteristics of the items below: Abrasive Machining, Honing, Lapping, Surface Grinding, Centerless Grinding.

Determine the induced current in a rectangular ohmic loop : A long current carrying wire has current changing with time according to I = At where A > 0 is a constant and t is time. Find the induced current in a rectangular Ohmic loop that is oriented

What will be the composition of the vapor stream : A compressed liquid mixture of 42 mol percent n-hexane (1) and 58 mol percent ethane (2) is to be fed to a flash tank where the pressure is reduced and a liquid and vapor stream separated. The flashing operation will be carried out at 32 °C. The liqu..

How much work is done on the canister : The only force acting on a 4.2 kg canister that is moving in an xy plane has a magnitude of 5.3 N. How much work is done on the canister by the 5.3 N forces during this time.

Vapor power plant operates at steady state : A well-insulated tank in a vapor power plant operates at steady state. Water enters at inlet 1 at a rate of 125lb/s at 14.7lbf/in^2. Make up water to replenish steam losses from the plant enters at inlet 2 at a rate of 10 lb/s at 14.7 lbf/in^2 and 60..

Rate of heat transfer to the steam in the reheater : Air enters a compressor at 105 kPa and 300 K with a volumetric flow rate of 12 m3 /min and exits at 1200 kPa and 400 K. Heat transfer occurs at a rate of 2 kW from the compressor to its surroundings. Assuming ideal-gas behavior for air, steady flow, ..

What net torque must be applied to the wheel : A small grinding wheel has a moment of inertia of 4.0×105kg.m2. What net torque must be applied to the wheel for its angular acceleration to be 150rad/s2.

Steam enters the high-pressure turbine : In a reheat-cycle power plant, steam enters the high-pressure turbine at 5 MPa, 450°C, and expands to 0.5 MPa, after which it is reheated to 450°C. The steam is then expanded through the low-pressure turbine to 7.5 kPa. Liquid water leaves the conden..

User Account

All Pages