How much time has pasted when the density of the tank

Reference no: EM13528804

A 20,000 gal. capacity tank contains 8,000 gals. ofwater/solids mixture at a density of 12 pounds per gal.(ppg). Fresh water (8.34 ppg) is added at a rate of 10 gallons per minute(gpm). At the same time fluid is being drained from the bottom ofthe tanks at 5 gpm. Assume perfect mixing what is the fluiddensity (ppg) when the tank volume equals 10,000 gals?

How much time has pasted when the density of the tank is 10ppg?

Reference no: EM13528804

Questions Cloud

How could a more precise estimate of the flowrate be obtain : A suppressed rectangular weir is being used to measure flows in anirrigation canal. The weir is 5 m wide and 2m high and, under floodconditions, the upstream and downstream depths are measured at 2.5mand 2.3 m, respectively.

A certain stell tape for wich the the coefficient of expans : A certain stell tape, for wich the the coefficient of expansion is 0.00000645, is exactly 100 ft long68 farenheit. at 15 farenheiit the length of the tape is howmany feet?

Is it possible that ccl4 could serve as anelectron acceptor : IN in-situ bioremediation ,an electron donor such as acetateis typically added and is oxidized to provide the electrons for thereduction of CCl4, in ground water devoid of oxygen ,nitrate typically serves as the electron acceptor.using data fromhalf ..

This has to be solved using the slope deflection method for : So, B is the corner of the L. On member BC there is a uniform distributed load of 10 kN/m. This has to be solved using the Slope Deflection Method for Frames.

How much time has pasted when the density of the tank : A 20,000 gal. capacity tank contains 8,000 gals. ofwater/solids mixture at a density of 12 pounds per gal.(ppg). Fresh water (8.34 ppg) is added at a rate of 10 gallons per minute(gpm).

How many pounds of concrete must be attached to beam : How many pounds of concrete (γ=150 lb/ft3) must be attached to a beam having a volume of 4.0 ft3(s.g.=0.65) to cause both to sink?

Determine the largest loadwhich can be applied : A block of 250mm length and 50x40mm cross section is tosupport a centric compressive load P. The material to be usedis a bronze for which E = 95GPa. knowing that the normal stress must notexceed 80 MPa and that the decrease in length of the block sho..

What will be the uniform load so to get the maximum : If a W14x53 is 20 ft long (simply supported) and is loadeduniformly to its moment capacity what is the maximumdeflection? What will be the uniform load so to get the maximum deflection?

Why do eukaryotes have linear dna : why do prokaryotes have circcular dna and why do eukaryotes have linear dna? Why are menstrual and ovarian cycle considered to be made ofmany feedback mechanisms?

User Account

All Pages