How much time can be represented before counter overflows

Assignment Help Electrical Engineering
Reference no: EM13281812

A 16-bit counter is used to keep track of seconds in a real-timecontrol system. If the counter is used to hold the number of elapsed seconds since an event hasoccurred, how much time can be represented before the counter overflows and the result is erroneous?

Reference no: EM13281812

Questions Cloud

What is the maximum initial cost the company : What is the maximum initial cost the company would be willing to pay for the project?
Determine the hysteresis loss if the apparatus is connected : Determine the hysteresis loss if the apparatus isconnected to a 60 Hz source whose voltage is such as to cause theflux density to be 62 percent of it's rated value. Assume that theSteinmetz exponent is 1.4.
Calculate the electric flux through a rectangular plane : An electric eld of magnitude 3.5 kN/C is applied along the x axis. Calculate the electric flux through a rectangular plane 0.35 m wide and 0.7 m
Explain weight of water will be lost if the sample is heated : For a 5.0 gram sample of each of the following, what weight of water will be lost if the sample is heated to constant weight: CoCl?*9H?O; CuSO?*5H?O; ZnSO?*4H?O; BaCl?*2H?O.
How much time can be represented before counter overflows : If the counter is used to hold the number of elapsed seconds since an event hasoccurred, how much time can be represented before the counter overflows and the result is erroneous.
What is the maximum amount the firm should pay : Which investment should be considered? (for any credit, show your work). Use a 9.5% discount rate. Hint: A discount rate gives you the clue that you should perform a present value analysis on each investment.
What is the semimajor axis of the satellites orbit : Flight to Mars. To send a satellite from Earth to Mars, a rocket must accelerate the satellite until it is in the correct elliptical orbit around the sun. What is the semimajor axis of the satellite's orbit
Define the rate of change of temperature divided by the rate : Consider uJT=(dT/dP)H. (this means the rate of change of Temperature divided by the rate of change of pressure at constant enthalpy)
What is the fundamental period of the discrete-time signal : Consider the discrete-time sinusoid given by x[n] = A cos(ω n+ φ), where x[n] may or may not be periodic. For it tobe periodic with a period of N, it must satisfy x[n] = x[n + N] forall integers n.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Derive a state table for the fsm that produces z

During four consecutive clock pulses, a sequence of four values of the x signal is applied. Derive a state table for the FSM that produces z = 1 when it detects that either the sequence 1001 or 0111 has been applied; otherwise, z = 0. After the fo..

  What is the number of possible frequency assignments

The MFSK scheme is used in conjunction with an FHSS scheme that hops among 4 different carrier frequencies. What is the number of possible frequency assignments. List the possible frequency assignments.

  How many turns are required for a circular loop

How many turns are required for a circular loop of 100-mm radius to develop a peak emf of 10mV if the loop rotates 30r/s in the earth's magnetic field Take B = 60E-6T.

  When the energy stored in the capacitor will be half

A capacitor of capacitance C=10-6 F is discharged through the resistor of resistance R=10 Ohm. (Switch is closed at t=0) When the energy stored in the capacitor will be half of its initial value

  Determine the capacitance of the two-wire line

Capacitance can be altered by bringing the two wire line close to ground. (a) Apply the method of images to determine the Capacitance of the two-wire line shown in the figure, where the lower wire is suspended a distance from the PEC ground.

  What charge must be on each plate

An electric field of 3.10×105 is desired between two parallel plates, each of area 36.0 and separated by 0.620 of air.What charge must be on each plate?

  What is torsional constant of hair spring connected to coil

A rectuangular coil having area 5 X 10^-4 m^2 and 60 turns in pivoted about one of its vertical sides. The coil is in a radial horizontal feild of 90 G. What is the torsional constant of the hair spring connected to the coil.

  Write down the generic form of the convolution integral

For x(t) --> Linear System --> y(t), x(t) = u(t)-u(t-1) and h(t) = 2e^-t*u(t)  Sketch x(t) and h(t) Write down the generic form of the convolution integral Calculate y(t) for t 1, using the convolution integral method.

  What is the measured period and frequency of the waveform

An oscilloscope shows the period of an ac waveform to be 3.5 horizontal divisions when the timebase control is set to "10 ms/Div". What is the measured period and frequency of the waveform

  Which part of the magnetic circuits stores more power

In transformer designs, often you can find an air gap in the core. In all the electric machines, there is an air gap between the stator and rotor. In both cases, flux will go through both core material and the air gap.

  What would happen if placed two electrons near each other

Some of the particles comprising atoms react to each other in a way that scientists categorize as electric charge. There are two fundamental types of electric charge: positive and negative.

  Desing a mod-16 asynchrous ripple up counter

Desing a mod-16 asynchrous ripple up counter by using j-k flip-flops. You need to design a j-k flip flop first and use it as the component in mod-16 up counter design. Show both j-k flip-flop design implementation results .

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd