How much hydrogen would be needed

Assignment Help Electrical Engineering
Reference no: EM13218361

An ideal PEM cell needs 30.35 g H2 to produce one kWh of electrical output. Suppose an electric car can travel 10 miles per kWh. How much hydrogen would be needed to give the car a range of 300 miles if the source of electricity is an on-board fuel cell with an efficiency that is 50% of the ideal?

Reference no: EM13218361

Questions Cloud

What is value that should be used as p for owned vehicle : A truck was purchased 3 years ago for $45,000 and can be sold today for $24,000. The operating costs are $9,000 per year, and it is expected to last 4 more years with a $5,000 salvage value. A new truck, which will perform that same service.
Determine the speed of the wave travelling on the line : An overhead line with an inductance of 1.33 mH/km and capacitance of 8.34 nF/km is connected to an underground cable with an inductance of 0.266 mH/km and capacitance of 166 nF/km.
Describe stock solutions of glucose : Given stock solutions of glucose (1M), aparagine (100 mM) and NaH2PO4 (50 mM), how much of each solution do you need to prepare 500 mL of a reagent that contains 0.05 M glucose
Explain how many megajoules of energy in the form of heat : how many megajoules of energy in the form of heat can be produced per year (365 days) by the heater
How much hydrogen would be needed : How much hydrogen would be needed to give the car a range of 300 miles if the source of electricity is an on-board fuel cell with an efficiency that is 50% of the ideal?
Calculate the average torque and maximum torque : When the two windings are connected to a a.c supply of 50hz, the field current is 0.1A, the armature current is 100A and the phase difference between them is 60 degree. calculate the average torque and maximum torque.
How to determine present worth for benefit and cost : The benefits associated with a nuclear power plant cooling water filtration project located on the Ohio River are $10,000 per year forever starting in year 1. The costs are $50,000 in year 0 and $50,000 in year 2. What is the B/C ratio at i=10% pe..
Compute the pressure in the mindanao trench : Calculate the pressure in the mindanao trench. depth = 11.5 km and the average mass density of sea water
What is the actual value of the irr on the incremental cost : a) Construct a choice table for interest rates from 0% to 100%. b) Which roof should you choose if your MARR is 12% what is the actual value of the IRR on the incremental cost?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the modulation used to transmit hdtv signals

What is the modulation used to transmit HDTV signals over the air in US terrestrial broadcasting? What is the transmitted bit rate and the compression method?

  Determine the response of the system

Determine the response of the system when aunit step is applied at input.

  Vital information about rc series circuit

Important information about RC Series Circuit, An RC series circuit has a voltage source of 10Vac, a resistor of 10ohms, and a capacitor with an impedance of -j10ohms

  Find out the minimum signal to noise ratio

Determine the minimum signal to noise ratio (s/n) in dB required in each communication channel to achieve a data rate of 270 kbps?

  Define static electricity

Define static electricity and State five sources of static electricity and Describe three methods used to reduce hazards due to static electricity

  Explain deploy a wireless telephone system

You have a bandwidth of 10 MHz (per direction) in a single-cell system and want to deploy a wireless telephone system. You have the following options: analog 30-kHz channels (as in AMPS)

  Define the transmission line has an impedance

The transmission line has an impedance of 600 ohms and is terminated in a load of 600 ohms. The transmitter delivers an average power of 0.1 W to the input of the line.

  Find the illumination

A lamp of 100 candela is placed 1 m below a plane mirror which reflects 90% of light falling on it. The lamp is hung 4 m above ground. Find the illumination.

  Solve problem in control signal processing class

Help with problem in Control signal processing class, Consider the unity-feedback control system whose open-loop transfer function is

  Rc circuits: capacitor is completely discharged

Assume that capacitor is completely discharged when t

  What are the four characteristic parameters

What are the four characteristic parameters of transmission line? Which parameter is used to calculate the real loss? Which parameter is used to calculate the charging current? Which parameter is almost negligible and why?

  Define complex voltage

Complex Voltage = 10-j20. try to convert it to polar coordinate with my Ti 89 but I keep getting my answers in arc tan.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd