How much heat had to be transferred to the vessel

Reference no: EM13564988

Alkaloids are chemical compounds containing nitrogen that can be produced by plant cells. In an experiment, an insulated closed vessel 1.673 m3 in volume was injected with a dilute water solution containing two alkaloids: ajmalicine and serpentine. The temperature of the solution was 10°C. To obtain an essentially dry residue of alkaloids, all the water in the vessel was vaporized. Assume that the properties of water can be used in lieu of the properties of the solution. How much heat had to be transferred to the vessel if 1 kg of saturated liquid water initially at 10°C was completely vaporized to a final condition of 100°C and 1 atm?

Draw out the process and explain please!

Reference no: EM13564988

Questions Cloud

Determine the maximum possible flame temperature : Consider your cooking gas contains 80% propane and 20% butane. While burning on a cooktop, assume it burns with 200% excess air. If no heat is lost, determine the maximum possible flame temperature.

Find the coefficient of permeability of the clay for : A laboratory consolidation test was performed on a clayey soil specimen, which was drained on both top and bottom. The time for 50% consolidation was 6.2 minutes, and the specimen's thickness at 50% consolidation

Compute the amount of primary consolidation settlement that : A compressible 12-ft clay layer beneath a building is overlain by a stratum of sand and gravel and underlain by impermeable bedrock. The total expected primary consolidation settlement of the compressible clay layer due to the building load is 4.60 i..

What are the density volume-to-capacity ratio and level : A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment of freeway, the directional peak-hour volume is 3800 vehicles with 2% large trucks and 4% buses (no recreational vehicles), the peak-hour factor is 0...

How much heat had to be transferred to the vessel : Alkaloids are chemical compounds containing nitrogen that can be produced by plant cells. In an experiment, an insulated closed vessel 1.673 m3 in volume was injected with a dilute water solution containing two alkaloids: ajmalicine and serpentine.

Calculate the axial strain and the transverse strain in the : A rigid rectangular shelf is suspended from a rigid ceiling by mean of four rods of diameter .505 inches. The two rods to the left L1 and L2, are made of steel

What is the stress along the top edge and the bottom edge : A horizontal pre-stressing force of 500kN is applied to rectangler beam. the beam has a depth of 500mm and a width of 250mm. the force is applied at a distance of 80mm below the x-x axis. what is the stress along the top edge and the bottom edge caus..

What is the maximum column load in kips that could be placed : What is the maximum column load in kips that could be placed on a 4-ft square temporary footing on a sand for which the standard resistance is about N=15 and the water table is at the surface? A factor of safety of 2 is to be maintained against beari..

Determine the percent error n in replacing the sine and the : Determine the percent error n in replacing the sine and the tangent of an angle by the value of the angle in radians for angle values 5 degrees, 10 degrees, and 20 degrees. Explain the qualitative difference between the sine and tangent results

User Account

All Pages