How much charge must move through the battery

Assignment Help Electrical Engineering
Reference no: EM13227145

A certain battery has terminals labeled a and b. The battery voltage is vab = 12 V.

a) To increase the chemical energy stored in the battery by 600J, how much charge must move through the battery?

b) Should electrons move from a to b or from b to a?

Reference no: EM13227145

Questions Cloud

Determine the networks equivalent resistance : A network connected between terminals a and b consists of two parallel combinations that are in series. The first parallel combination is composed of a 10-phm resistor and a 15-ohm resistor. The second parallel combination is composed.
Explain what kind of standard is y : A solution containing an unknown amount of X and 10.25 mM of Y was run and gave peak areas of 8.20 and 6.50 cm2 respectively. What is the concentration of X in the unknown solution? What kind of standard is Y?
Determine the cost per kilowatt hour for the energy : Determine the cost per kilowatt hour for the energy delivered by a typical alkaline 9-V "transistor" battery that costs $1.95 and is capable of delivering a current of 50 mA for a period of 10 hours. (For comparison, the approximate cost of energy..
Compute the molar mass of the unknown gas : Calculate the molar mass of the unknown gas. (Remember that the faster the rate of effusion, the shorter the time required for effusion of 1.0 L; that is, rate and time are inversely proportional.)
How much charge must move through the battery : A certain battery has terminals labeled a and b. The battery voltage is vab = 12 V. a) To increase the chemical energy stored in the battery by 600J, how much charge must move through the battery
Why does the electron gain or lose energy : The charge carried by an electron is ?1.60×10?19 C. Suppose that an electron moves through a voltage of 120V from the negative polarity to the positive polarity. How much energy is transferred Does the electron gain or lose energy
Define what is the partial pressure of each component : A mixture of gases contains 2.89 g of N2, 5.38 g of H2, and 9.00 g of NH3. If the total pressure of the mixture is 2.24 atm, what is the partial pressure of each component?
Describe five potential challenges to starting : You are planning to begin a new business providing legal consulting services to the technology industry. Name and describe five potential challenges to starting this new business.
How the gps could be used for the propagation of signals : Build a C++ code for vehicle sensing device. Code is required to embed in the device so that then it must sense the location where the vehicle is currently present. The device must be able to track the location of the vehicle for its owner

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain an electric heating element is connected

An electric heating element is connected to a 110 v circuit and a current of 3.2 A is flowing through the element. How much energy is used up during a period

  Define dynamic ram that must be given a refresh cycle

Dynamic RAM that must be given a refresh cycle 64 times per ms. Each refresh operation requires 150 ns. memory cycle requires 250 ns.

  Compute the image frequency and its db of suppression

An AM broadcast receiver's pre-selector has a total effective Q of 90 to a received signal at 1180 kHz and uses an IF of 455 kHz. Calculate the image frequency and its dB of suppression.

  Determine log10x for each value of x

Determine log10 0.2 = log10 18/90, and compare to log10 18 - log10 90.

  How much power is delivered to the end of the combined fiber

Ten multimode glass fibers (n1 = 1.48, n2 = 1.45) are spliced together. Each fiber is 2 km long and has a loss rate 2-dB/km. Each splice adds 1 dB of loss. If the output power of the source is 7 dBm and radiates uniformly in a 60 degree half cone

  Compute the maximum and minimum spectral frequencies

Compute the maximum and minimum spectral frequencies received by a mobile traveling at a speed of 100 Km/hr. What is the frequency of the received signal if the mobile is moving in a direction perpendicular to the direction of arrival of the trans..

  How many atoms are there in the unit cell

(a) How many atoms are there in the unit cell characterizing the Si lattice (b) Verify that there are 4.994 X 1022 atoms/cm' in the Si lattice at room temperature. (c) Determine the eenter-to-center distance between nearest neighbors in the Si lattic..

  How to perform an economic analysis

For a new product sales are expected to be 2,000 products in year 1, increasing by 1,000 products each subsequent year to 5,000 products in year 4. Two different manufacturing equipment options are available a) Up front equipment purchase cost of $..

  Calculate the per unit resistance of this transformer

Efficiency in a power transformer is 98.6 percent when loaded such that its copper losses are five times its core losses. Calculate the per unit resistance of this transformer.

  What is the minimum sampling frequency for a/d conversion

A video signal contains light variations that change at a frequency as high as 3.5 MHz. What is the minimum sampling frequency for A/D conversion?

  Define transmit power

The signal to noise ratio at the receiver is required to be at least 17 dB. The average noise power at the receiver is 1 mW. The cable loss between the transmitter and the receiver is 2.5 dB/km

  Design a 4-bit decrementer using half-adders

Design a 4-bit decrementer using Half-adders and inverters as building blocks. The circuits impleents A-1=S. Draw the circuit diagram. Hint: consider addtion of the 2s complement of -1 =1111. Begin with a 4-bit adder circuit constructed with 1-bit..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd