How much charge flows through the battery in the interval

Assignment Help Electrical Engineering
Reference no: EM13266141

A typical "deep-cycle" battery (used for electric trolling motors for fishing boats) is capable of delivering 12.6 V and 10 A for a period of 10 hours. How much charge (in columbs) flows through the battery in this interval? How much energy does the battery deliver?

Reference no: EM13266141

Questions Cloud

Evaluate the heat required to convert : Calculate the heat required to convert 58.0 g of C2Cl3F3 from a liquid at 14.90 degrees C to a gas at 90.75 degrees C.
What kind of mirror is being used : A dentist's mirror is placed 2.5 cm from a tooth. The enlarged image is located 6.1 cm behind the mirror.  What kind of mirror (plane, concave, or convex) is being used
At what price would the bonds sell : Suppose that 2 years after the initial offering, the going interest rate had risen to 12%. At what price would the bonds sell?
Explain biological systems usually work at efficiency : Biological systems usually work at 65% efficiency. How many mL of ethanol can you obtain from the fermentation of 0.25 lbs of sucrose
How much charge flows through the battery in the interval : A typical "deep-cycle" battery (used for electric trolling motors for fishing boats) is capable of delivering 12.6 V and 10 A for a period of 10 hours. How much charge (in columbs) flows through the battery in this interval. How much energy does t..
Explain what is the correct name for the compound : How many distinct locations are there for a double bond in a five-carbon linear chain. What is the correct name for the compound, CH3CH2CH=CHCH2CH=CHCH3
Compare stored energy with the energy content per unit mass : If the energy stored in the fully charged battery is used to lift the battery with 100-percent efficiency, what height is attained. Assume that the acceleration due to gravity is 9.8 m/s2 and us constant with height.
Define what must be the value of kc for the same equilibrium : Given that Kp for 2SO2(g)+O2(g)=2SO3(g) equals 3.18 at 1000K. Figure out what must be the value of Kc for this same equilibrium.
Calculate the approximate force on a square meter of sail : Suppose the horizontal velocity of the wind against a sail is 5.5 m/s parallel to its front surface and 3.3 m/s along its back surface. Calculate the approximate force on a square meter of sail in N

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Why is there a thin region of one material type sandwiched

What are the names of the three regions of the bipolar junction transistor Why is there a thin region of one material type "sandwiched" between two layers of the opposite material type

  Define mobile communications base station

In a typical mobile communications base station (or cell site), a radio frequency (RF) signal is amplified in the base station and then sent (over cable) to the antennas at the top of the tower.

  Find time domain expressions for vbn

A positive sequence three phase source has Van(t)= 200cos(wt+120) V. Find time domain expressions for vbn(t), Vcn(t), Vab(t), Vbc(t), and Vca(t).

  What does the sensitivity of a sensor tells about the sensor

How would you know a system is linear by just looking at its input/output characteristic graph And what does the sensitivity of a sensor tells us about the sensor

  Determine the reactive power delivered to the load

An AC motor with impedance Z = 4.2 + j3.6 Ω is supplied by a 220 V, 60 Hz source. Determine the reactive power delivered to the load.

  Give empirical equations relating saturation temperature

Make a table showing Temperature as a function of pressure for Psat from 20 to 600 psia every 20 psi, and another table showing pressure as a function of temperature from 150 degrees to 350 degrees every 20 degrees.

  Explain how should the cut off frequencies be arranged

Can we build a bandpass filter using a low pass and a high pass filter combination. If your answer is yes, then how should the cut off frequencies be arranged. Illustrate your answer with a simple example.

  Design a sequential circuit with three d-type flip-flops

A sequential circuit with three D-type flip-flops Y1Y2Y3, input X and output Z is defined with the following input/output functions: D 1 = X Y 3 + X Y 1 Y 3 D 2 = X  ( Y  3 + Y 2 ) + X Y 2 Y 3 D 3 = X Y 3 + Y 2 Y 3 Z = Y3

  What is the open circuit voltage of the series connection

Three cells whose open-circuit voltages are each V are connected in series. What is the open circuit voltage of the series connection If the same three cells were connected in parallel

  Write programme to copy values from array1 to array2

Write a HCS12 assembly-language program that copies values from ARRAY1 to ARRAY2 until it copies 10 values, or a value in ARRAY1 that is equal to zero.

  When the radiator area a is a minimum for temperature ratio

A heat engine operating in outer space may be assumed equivalent to a Carnot engine operating between reservoirs at temperatures TH and Tc The only way heat can be discarded from the engine is by radiation

  Find total complex power absorbed by the wye-connected load

A tree-phase, 60Hz, 5MVA synchronous generator has balanced line-to-line voltages of 8320V at its terminals. if the generator is supplying power to delta-connected, balanced load of 5MVA at a 0.8 lagging power factor

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd