How many rollers are required for the project

Assignment Help Electrical Engineering

Reference no: EM131233695

An asphalt plant will produce 180 tph for a highway project. The mat will be 12 ft wide and 1!-in. thick, and will have a density of 115 lb/sy-in. A vibratory roller with a 66-in.-wide drum will be used for compaction. Assume a 50-min hour efficiency factor for the roller.

The overlap between adjacent laps and over edges will be 6-in. minimum. It is estimated that nonproductive travel will add about 15% to total travel.

From a test mat, it was found that three passes with the roller are required to achieve density. To account for acceleration and deceleration when changing directions, add 10% to the average roller speed to calculate a running speed. If it is desired to keep the rolling speed under 3 mph, how many rollers are required for the project?

Reference no: EM131233695

Questions Cloud

What is currently known about the question being asked : This is an investigation of what is currently known about the question being asked. Use background information from credible references to write a short summary about concepts in the lab.

Find the heat transfer and the entropy generation : A piston/cylinder contains 1 kg water at 150 kPa, 20?C. The piston is loaded, so the pressure is linear in volume. Heat is added from a 600?C source until the water is at 1 MPa, 500?C. Find the heat transfer and the entropy generation.

How many gallons of prime will be required : An asphalt distributor having a 10-ft-Iong spray bar will be used to apply a prime coat at a rate of 0.2 gaVsy.- How many gallons of prime will be required?

Set of vectors that is linearly dependent : (a) Let {v1, v2, v3} be a set of vectors that is linearly dependent. Show that for any other vector w, the larger set {v1, v2, v3, w} is also linearly dependent.

How many rollers are required for the project : An asphalt plant will produce 180 tph for a highway project. - If it is desired to keep the rolling speed under 3 mph, how many rollers are required for the project?

Find the change in specific exergy : Nitrogen flows in a pipe with a velocity of 300 m/s at 500 kPa, 300?C. What is its exergy with respect to an ambient at 100 kPa, 20?C?

Explain clearly whether you obtained the expected results : In this section, state clearly whether you obtained the expected results, and if the outcome was as expected. Note: You can use the lab data to help you discuss the results and what you learned.

Servant leadership cross religious and cultural lines : While servant leadership can be connected to biblical principles and Christianity, it is not exclusively tied to it. In what ways do the principles of servant leadership cross religious and cultural lines? Justify your opinions by providing specific ..

Find the compressor exit temperature : For the air system in the previous problem, find the increase in the air exergy from the inlet to the point of use. How much exergy was lost in the flow after the compressor exit?

User Account

All Pages