How many grams of water are in the same solution

Assignment Help Civil Engineering
Reference no: EM13315430

How many grams of perchloric acid, HClO4, are contained in 37.6 g of 70.5 wt% aqueous perchloric acid? How many grams of water are in the same solution?

Reference no: EM13315430

Questions Cloud

What is the cost of heating the water : Water has a specific heat capacity of 4186 J/kg C. A tank contains 500 kg of water at 10 C. what is the cost of heating the water
Determine how many moles of hclo4 are in 1 l : The density of 70.5 wt% aqueous perchloric acid is 1.67 g/mL. a. How many grams of solution are in 1.000 L b. How many grams of HClO4 are in 1.000 L c. How many moles of HClO4 are in 1.000 L
Cost benefit analysis : Australian Standard for lighting to firstly ensure compliance with the standard and compatibility with current fixtures (T8 linear fluorescent);
Find the frequency of the wave : The distance between two successive minima of a transverse wave is 2.57 m. Five crests of the wave pass a given point along the direction of travel every 12.4 s. Find the frequency of the wave
How many grams of water are in the same solution : How many grams of perchloric acid, HClO4, are contained in 37.6 g of 70.5 wt% aqueous perchloric acid. How many grams of water are in the same solution.
Determine the governing load combination for both moments : A beam that is part of a rigid frame has end moments and mid-span moments for dead, live, and earthquake loads. Determine the governing load combination for both negative and positive moments at the ends and mid-span of the beam.
Calculate the total weights and values of each subset : Use the decrease-by-one technique to generate the power set and calculate the total weights and values of each subset, then find the largest value that fits into the knapsack and output that value.
Determine what is the actual length of the line for steel : A 100ft steel tape measure correctly when supported throughout its length under a tension of 1- lb and at a temperature of 72F.It is used on the field at a tension of 18 lb and supported at the two ends only.
How many watts of power would it take to heat 1 l of water : How many watts of power would it take to heat 1 L of water(weighing 1.0 kg) by 10 degrees Celsius n 1.0 h Assume no heat losses occur, so all of the energy expneded goes into heating the water.

Reviews

Write a Review

Civil Engineering Questions & Answers

  How to specify the state of stress in the wall of the tank

The tank has an inner diameter of 1.5 m and a wall thickness of 18 mm. If the pressure in the tank is p=1.20MPa, determine the force in the 16 bolts that are used to attach the cap to the tank. Also, specify the state of stress in the wall of the ..

  Determine what is the runoff rate into the inlet grate

A paved parking lot section has a uniform slope over a length of 100 m (in the flow direction) from the point of a drainage area divide to the inlet grate, which extends across the lot width of 30 m.

  Determine what would be the coefficient of permeability

hydraulic conductivity of soil is .009cm/sec at room tmeperature of 28*C. what would be the coefficient of permeability at 20*C

  How much money will dave accumulate in the savings account

How much money will dave accumulate in his savings account at the end of 5 years if he makes monthly deposits of $50 begining one month from now. The annual nominal interest rate is 9%

  Compute the normal flow rate through the channel

A large drainage channel has a trapezoidal cross section with a bottom width of 75 feet and bank side slopes of 4:1 (H:V). If the normal depth of flow is 25 feet, compute the normal flow rate through the channel (Q in cfs).

  Determine how to calculate ph of water at 25 degrees

How do you calculate pH of water at 25 degrees that contains 0.6580mg/l carbonic acid. Assume that [H+] =[HCO3-]at equilibriumand ignore the dissociation of water.

  Determine force exerted by the hydraulic cylinder on boom

A hoist mechanism is attached to the back of a pickup truck. The crate being moved by the hoist shown below weighs 200 lbs. Note: Point A is directly above point B and the vertical distance between points A and B is 16 inches.

  Find the total length of pipe that must pass through furnace

The boiling water passes through copper pipes that have a wall thickness of 4 millimeters and a surface area of 0.12 square meters per meter length of the pipe. Find the total length of pipe (there are actually many pipes in parallel)

  Determine the maximum constant speed of the motorcyclist

A motorcyclist travels around a curved path that has a radius of 200 . While traveling around the curved path, the motorcyclist increases speed by 1.25 . If the motorcyclist starts from rest, determine the time needed to reach an acceleration of 5...

  Effective vertical stresses of the clay layer

The saturated unit weight of the clay is 20kN/m 3 and that of the sand 19 kN/m 3 ; above the water table the unit weight of the sand is 16.5 kN/m 3 . Calculate the effective vertical stresses at the top and bottom of the clay layer.

  Find what is the space-mean speed of the traffic at capacity

on a specific westbound section of highway studies show that the speed-density relationship is u= uf [1-(k/kf)^3.5] It is known that the capacity is 4200 veh/h and the jam density is 210 veh/mi.

  What ration of lengths will cause the maximum shear stress

A solid circular shaft AC of total length L=L1+L2 is fixed against rotation at ends A and C and is loaded by a tourqe T_b at joint B. If the diameter of the two segements of the shaft are in ratio d2/d1

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd