How many feet of head must the pump add to achieve

Assignment Help Civil Engineering
Reference no: EM13312137

At a pumped storage facility, water is pumped from a large reservoir to a point 150 feet above the resevoir. How many feet of head must the pump add to achieve 10,000 lbm/hr flow through a 24 inch pipe with a friction head loss of 1.5 feet?

Reference no: EM13312137

Questions Cloud

Describe a modification to the random port scan : Describe a modification to the random port scan, as describe in previous exercise, so that it still use a randomly generated sequence of port numbers but will now have exactly the same number of attempted TCP connections as a sequential port scan.
Calculate the fluid velocities at the two ends : Assume frictionless flow in a long, horizontal, conical pipe. The diameter is 12 inches at one end and 6 inches at the other. The pressure head at the smaller end is 16 feet of water.
Explain the percent by mass of nitrogen in nh4no3 : Which expression represents the percent by mass of nitrogen in NH4NO3. A) 14 g N/80 g NH NO 100% B) 28 g N/80 g NH NO 100% C) 80 g NH NO /14 g N 100% D) 80 g NH NO /28 g N 100%
Create an master production schedule : Create an Master Production Schedule and a Material Requirement Planning Chart
How many feet of head must the pump add to achieve : At a pumped storage facility, water is pumped from a large reservoir to a point 150 feet above the resevoir. How many feet of head must the pump add to achieve 10,000 lbm/hr flow through a 24 inch pipe with a friction head loss of 1.5 feet
Find the velocity of the wood : A block of wood of mass 4.85 kg rests on a horizontal frictionless surface. find the velocity of the wood after the bullet has passed through
What is the fluid velocity in the pipe in feet per second : Water enters a pipe at 100 psig and 70 degrees F. The density of water under these conditions is 62.3 lbm/ft^3. The pipe has an inside diameter of 4.5 inches. The mass flow rate of the water is measured to be 7500 lbm/hr.
What is level of service before and after the development : A divided multilane highway in a recreational area (fp = 0.90) has four lanes (two lanes in each direction) and is on rolling terrain. The highway has 10-ft lanes with a 6-ft right-side shoulder and a 3-fl left-side shoulder.
What is the acceleration of the two teams : Two teams of nine members each engage in a tug of war. The first team's members have average masses of 65 kg and exert average forces of 1350 N horizontally. What is the acceleration of the two teams

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the new water content

A soil sample with a water content of 14.5% and unit weight of 128.2 lb/cu. ft. was dried to a unit weight of 118.8 lb/cu. ft. without changing its void ratio. What is its new water content (in %)?

  Determine what would be the total consolidation settlement

A normally consolidated clay layer in the field has a thickness of 3.2 m with an average effective stress of 70 kN/m^2. A laboratory consolidation test on the clay gave the following results: Pressure (kN/m^2)=100, 200 Void Ratio=0.905, 0.815

  Estimate the required surface area

Estimate the required surface area (A), and the diameter and the depth of the tank.

  Calculate how many lbs of co2 are produced per gallon

Diesel fuel has an average chemical formula of C12H23 and a density of 6.45 lb/gal. Calculate how many lbs of CO2 are produced per gallon of diesel burned (assume complete combustion).

  What is the maximum horsepower that the system can produce

A ssume that one half of the energy incident on the collector goes to this reservoir, which, in turn, serves as a source for a heat engine. If the temperature of the atmosphere is 70 F,

  Determine entropy change of air during compression process

Air is compressed from an initial state of 100 kpa and 170 *C to a final state of 600 kpa and 57 *c. Determine the entropy change of air during the compression process by using a) property values from the air table and b) average specific heats

  Find modulus of elasticity of pavement for corner deflection

The pavement is on a base which has a modulus of subgrade reaction of 250 pci. A 17,000 lb corner load is applied (al is 7 inches). Using the revised Westergaard equations, find the modulus of elasticity of the pavement if a corner deflection of 0..

  What is max mole fraction of methanol that can be achieved

A solution containing 30% methanol (by mol) is flashed to 1 bar, 70.82°C. Determine the phase of the system; if 2 phases, report the compositions and relative amounts of each phase.

  What is the maximum step height

An open rectangular channel is 50 feet wide, flowing at a depth of 5 feet, and is carrying 1000 cubic feet per second. What is the maximum step height than can be placed into the flow without disturbing the upstream depth, without acting as a chok..

  Determine the initial weight and final density of the water

A steel tank hold 120 ft^3 of water at atmospheric pressure(14.7psi and 68.4 degrees f). the water is subjected to a 100 fold increase in pressure. determine the initial weight and final density of the water if the volume decreases by .545 ft ^3.

  Determne the angular velocity at the instint theta

When theta=0 degrees , the assembly is held at rest, and the torsional spring is untwisted. If the assembly is released and falls downward, determne the angular velocity at the instint theta=90.

  Determine the change in effective stress in the clay

a layer of sand 4 m thick, overlies a layer below permeability clay, 5m thick. the bulk unit weight of the sand is 16.5 KN/m^3 and its saturated unit weight is 18 KN/m^3. the saturated unit weight of the clay is 21 kN/m^3.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd