Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.how many cubic yards of aggregate must be ordered for a road base 16 inches thick and 2000 feet long with a top width of 30 ft, if the side slopes are one on one, or 45 degree?
2.Determine a set of rectangular beam design values (b),( d) and (As) area of steel, that will be needed to support a factored bending moment (Mu=450 Kip-ft). Use (f’c=4,500 psi) and (fy=40,000 psi). Use beam width of approximately 0.6 times effective depth. (b= 0.6 d).
3.Why is aluminum preferred over iron-based alloys in the aerospace industry and iron-based alloys over aluminum in structural numbers of bridges and buildings?
4.What is the total deformation in a 15' 2'' square steel hanger that supports a 36000 pound load? E for steel is 29000000 Psi
Apiece of corroded steel plate was found in a submerged ocean vessel. it was estimated that the original area of the plate was 62.5cm 2 and approximately 2.8k had corroded away during the submersion.
Looking a wood (pine) deck material. It's a simple 8' by 8' deck. There's a support beam holding up this deck. Other end is connected to building.
What is the total moment M due to the force F about point O. Assume that moments acting counterclockwise about point O are positive whereas moments acting clockwise are negative.
The Purification of hydrogen gas by diffusion through apalladium sheet was discussed. compute the number of kilograms ofhydrogen that pass per hour through a 6-mm- thick sheet of palladium having an area of 0.25 m^2 at 600
The partition is free to move and allows conduction from one gas to the other without energy storage in the partition itself. The air and carbon dioxide each behave as ideal gases. Determine the final equilibrium temperature
The velocity distribution for the flow of oil (SAE 20W) at 150 degrees between two plates is given by y(y-4) mm/s, where y is measured in mm and the space between the plates is 4mm. Determine the shear stress at each wall and the maximum shear str..
An irrigation channel is constructed of earth and is 8.1km long and has a capacity of 10 m^3/s for a flow depth of 2m. The cross section is trapezoidal with a bid width of 8 m and side slopes of 2 horizontal to 1 vertical.
Write a MATLAB program that loads the sensor_new.dat file. The sensor readings were actually taken every second over a period from 0 to 19 seconds. Create a time vector going from 0 to 19 in 1 second increments.
If the takeoff speed of an airplane is 120 mph at sea level, what will it be at Denver (elevation =5000 ft) Use properties of the US Standard Atmosphere
A thin-walled circular tube has an average diameter of 100 mm and a wall thickness of 4 mm. It is subject to torque of 4 kNm and a compressive axial force of 40 kN.
a room having a total heat gain of 35,000 btuh is to be maintained at 80 DB and 62 WB. the air is supplied to the room at 60 DB and 55 WB. find the quanity of air to be supplied.
A 2:1 natural slope is underlain by a 3-m thick (measured vertically) soil cover over bedrock. Compute the factor of safety by using an effective stress infinite slope analysis with c'=0 and o' (theres a line between that)= 35 degrees for the soil..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd