How long will it take to concentrate the solution

Assignment Help Civil Engineering
Reference no: EM13563750

D) 150,000 mol of aqueous phosphoric acid (H3PO4) solution contains 5.00% H3PO4 by moles. The solution is concentrated by adding pure H3PO4 at a rate of 20.0 L/min.

D.1) Write a differential mole balance on H3PO4 and write the initial condition. (Hint: Start by defining np to be the total quantity of H3PO4 in the tank at any given time.

D.2) Solve to find np(t). Then derive an expression for the mole fraction of H3PO4 in the solution, xp(t).

D.3) How long will it take to concentrate the solution to 15% H3PO4?

Reference no: EM13563750

Questions Cloud

What would be the fraction of trucks entering the section : Consider a highway section where traffic is stationary, all trucks travel at speed s and cars at speed v. If aerial surveillance revealed that trucks were a fraction p of the vehicles on a photograph, what would be the fraction of trucks entering the..
What steady-state concentration of co will be observed : A person may demonstrate observable effects on the central nervous system when exposed to carbon monoxide at a concentration of 50 ppm, may lose consciousness at a concentration of 250 ppm, and may die at a concentration of 750 ppm. A "typical" urban..
Determine the ph of water in a closed calcium carbonate : Determine the pH of water in a closed Calcium Carbonate Aquifer. Assume that the temperature is again 25oC, and that the aquifer material is pure Calcium Carbonate. Again you must list all species that exist in the system and all equations.
Give one reason why this should be considered by management : A chemical plant produces a process wastewater that contains a relatively high concentration of a small number of nontoxic organic compounds, but very low concentrations of solids or salts.
How long will it take to concentrate the solution : 150,000 mol of aqueous phosphoric acid (H3PO4) solution contains 5.00% H3PO4 by moles. The solution is concentrated by adding pure H3PO4 at a rate of 20.0 L/min.
Calculate the pressure and mole fractions in the vapor : Water is used in a heat exchange to cool 5 kg/s of air from 400 C to 200 C. Calculate (a) the minimum mass flux (kg/s) of the water and (b) the quantity of heat transferred (MJ) to the water each second. The water enters at 20 C and leave at 30 C.
Balance the latitudes and departures by using the compass : A four-sided closed field traverse has the following angles. A = 81 degrees 22%u201930%u201D, B = 72 degrees 32%u201930%u201D, C = 89 degrees 39%u201930%u201D, D =116 degrees 23%u201930%u201D.
Determine the maximum velocity that the skier will achieve : A person with a mass of 200kg wearing snow skis is gliding down a long slope at an angle of 20 degrees. Each ski is 200cm long and 5 cm wide. The pressure of the skis on the snow melts a thin layer of water so that a .1mm layer of water exists under ..
What volume of naocl will be needed : If the plant uses sodium hypochlorite instead, what volume of NaOCl will be needed? Assume that the dry density of NaOCl is 1.2 kg/L and that 1 mg/L of dissolved NaOCl is equivalent to 1 mg/L of dissolved Cl2.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the steady-state concentration of radon

Consider a house into which radon is emitted through cracks in the basement. The total volume of the house is 650 m3 (assume that the volume is well mixed throughout).

  Determine storage 1 hr later if average rates are given

The storage in a reach of river is 20,000 m^3 at a given time. Determine the storage 1 hr later if the average rates of in flow and out flow during the hour are 20 and 18 m^3/s, respectively

  Determine the specific weight of the wood

A solid wooden cube (.5*.5*.5 m^3) is floating in water and 0.2 of the cube extends above the water surface. Determine the specific weight of the wood.

  Determine smallest velocity vo for which package will reach

A small package of weight W is projected into a vertical return loop at A with a velocity Vo. The package travels without friction along a circle of radius "r" and is deposited on a horizontal surface at C.

  Find what would be the minimum number of truckloads

Soil is excavated from a borrow to construct an embankment with a net volume of 50,000 cy with 95% of Modified Proctor maximum dry density of 110 pcf with a Modified Proctor optimum water content of 8%.

  Determine what is the maximum flow rate that can be pumped

assume the pipe diameter is 4-inches, (f = 0.035), Distance from BC is 15-feet, distance DE is 180-feet and z = 60-feet. The elevation of C is 10-feet above the lower water surface.

  Computer the percent voids in total mix

An aggregate blend is composed of 53% coarse aggregate by weight (sp. gr. 2.702), 43% fine aggregate (sp. gr. 2.621), and 4% filler (sp. gr. 2.779)/ The compacted specimen contains 6% asphalt binder (sp. gr. 1.052) by weight of total mix, and has a b..

  Compute the cars stopping distance and time

at s=0 the driver applies the brakes hard enough to cause the car to skid. Assume that the car keeps sliding until it stops, and assume that throughout this process acceleration is a= -7.4556. compute the car's stopping distance and time.

  Determine the resulting angular velocity of the wheel

A bolt located 50 mm fm he center of an automobile wheel is tightened by applying the couple for 0.10 s. Assuming that the wheel is free to rotate and is initially at rest, determine the resulting angular velocity of the wheel.

  Determine the sequent depth

A real estate broker charges a fixed fee of $50 plus a 6% commission on the landowner's profit. If this is uniformly distributed between 0$ and 2000$, find the probability distribution of the brokers total fees.

  Slope deflection approach to find complete deflection

Use slope deflection approach to find complete deflection solutions for a fixed fixed beam with concentrated force, F, distance a from left end and axial load P.

  Calculate the forces exerted by the water on the bend

Water flows through a horizotal 45 deg reducing bend with a 36 inch. diameter upstream and a 24 inch diameter downstream, at the rate of 20 cfs under a pressure of 15 psi at the upstream end of the bend. Neglecting head loss in the bend, calculate..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd