How are you to tell what the reynols number is

Assignment Help Civil Engineering
Reference no: EM13534534

A rectangular concrete channel 4m wide on a slope of 0.002 is designed to carry water(T = 10 C) at discharge rate 25m^3/s. Estimate the uniform flow depth for these conditions? If you use darcy weisbech equation how are you to tell what the Reynold's number is, do you need that?

Reference no: EM13534534

Questions Cloud

Determine analytically whether or not it is linear : To prove that a system islinear or time-invariant, the property must be demonstrated for all possible input/output pairsand all delays. On the other hand, to prove that a system is not linear or not time-variant,the property can be demonstrated with ..
Determine the prism constant : A 100 ft cut steel tape was used to check the layout of a building wall. the rear surveyor held 42 ft while the head surveyor cut 0.33 ft. what is the distance measured?
How much must the temperature of the ring be increased : A steel ring of internal radius 499.8 mm is to be shrink-fitat normal (room) temperature over a rigid cylinder of radium r =500 mm
The horizontal distance between the point : The elevtion of M is 875 . a transit was set at point M and a leveling rod was held vertically at point N. the horizontal cross line of the telescope was inclined so the reading of the horizontal cross line
How are you to tell what the reynols number is : A rectangular concrete channel 4m wide on a slope of 0.002 is designed to carry water(T = 10 C) at discharge rate 25m^3/s. Estimate the uniform flow depth for these conditions?
How do you find this answer : A 14in diameter pipe pile is driven 50ft into a dry loose sandwhose unit weight is 105 pcf. The angle of internal frictionis 33 degrees. Compute the safe axial downward loading
What will be the grade elevation at station : The grade elevation at station 25+00 is to be 946.52 ft. What will be the grade elevation at station 34+86.20 if the grade linerises at the rate of 1.785% between these two points?
Find the percentage of aceticacid ionized in the solution : One liter of a solution is made by adding 3grams of acetic acid (HAc) to distilled water. The molecular weightof acetic acid is 60.052. The acid dissociation constant for aceticacid
Determine the pressure at a stagnation point on that stream : At a given point on a horizontal streamline in flowing air, thestatic pressure is -2 psi (ie vacuum) and velocity is 150 ft/s.Determine the pressure at a stagnation point on thatstreamline?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Compute how much the 10 feet thick clay layer swelled

A 10 feet thick clay that was unsaturated with a unit weight of 108 pcf and a water content of 20% gets saturated and also swells by 20% due to rain. G=2.70.

  What is the average degree of consolidation for clay layer

A normally consolidated clay layer is 4 m thick (one way drainage). From the application of a given pressure, the total anticipated primary consolidation settlement will be 80mm. What is the average degree of consolidation for the clay layer.

  Explain how to compute the energy input to the motor

Compute the motor size required to pump 28.3 cms through a 3,050 m long, 3.66 m diameter pipeline to an upper reservoir 610 m above the lower reservoir. Use a friction facter of 0.02 and a pump efficiency of 80 percent.

  What is the smallest number of bulbs to be purchased

A company manufactures a brand of light bulbs with a lifetime in month that is normally distribute with a mean=3 and a variance=1. A consumer buys a number of these bulbs with the intention of replacing them successively as they burn out.

  Determine the required do concentration in the treatment

Given the following information, determine the required DO concentration in the treatment plant effluent discharge in order to ensure that at no point downstream the DO in the river drops below 4 mg/L

  Give criteria used to organize systematic mineral collection

For some minerals color is a diagnostic property making identification rather easy. However, certain minerals can also occur in a wide variety of colors making color a poor tool for identification. List different colors for the mineral quartz lo..

  Check whether the pressure is adequate for service

If the elevation of the pipeline at the treatment plant is 125 m, estimate the pressure in the pipeline 1 km downstream where the elevation if 110 m. Hint: Use the Colebrook equation to estimate f, and the energy equation to estimate P2 .

  How much horizontal distance is there from prism to point a

using a prism and prism pole in conjunction with a total station, the bottom of the prism pole is placed on point A. the distance from the bottom of the prism pole to the center of the prism (HR) is 4.97 feet.

  Determine the required mass of c and the length of the cable

if D has a mass of 600 kg, determine the required mass of C, the maximum sag h of the cable, and the length of the cable between the pulleys A and B. The Beam has a mass per unit length of 50 kg/m.

  Determine the amount of cover over a culvert

A vertical curve of 600 ft in length is used to connect two tangents with the following locations: Tangent 1.- Point 1, Sta = 59+00, El = 1250.0' Point 2, Sta = 72+00, El = 1190.0' Tangent 2.- Point 1, Sta = 72+00, El = 1190.0' Point 2, Sta = 84+0..

  Determine the total solids in the sample

A surface water sample has been evaporated until dry in a crucible dish. The dry (tare) weight of the crucible is 44.642gm. The weight of the residue plus the cruciible is 44.6484gm.

  What is the oil flowrate in stb

Two wells had been drilled on 40-acre spacing. Well 1 is injectionand Well 2 is producing well. Downhole injection pressure is 8500psi, and bottomhole pressure in producing well is 2400 psi.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd