Reference no: EM13865972
Problem 1: A hollow shaft has to transmit 6MW at 150 rev/min. The maximum allowable stress is not to exceed 60MN/m2 nor the angle of twist 0.3deg per meter length of shafting. If the outside diameter of the shaft is 300mm find the minimum thickness of the hollow shaft to satisfy the above conditions. G = 80 GN/m2.
Problem 2: A steel shaft 3m long is transmitting 1MW at 240 rev/min. The working conditions to be satisfied by the shaft are:
That the shaft must not twist more than 0.02 radian on a length of 10 diameters,
That the working stress must not exceed 60 MN/m2.
If the modulus of rigidity of steel is 80 Gn/m2 what is
(a) The diameter of the shaft required
(b) The actual working stress,
(c) The angle of twist of the 3m length
Problem 3: For a solid or hollow shaft of uniform circular cross-section throughout its length, the theory of pure states that:
T/J = Gθ/l = r/R
Derive the above expression from first principals
|
Leadership and decision-making concepts
: leadership and decision-making concepts
|
|
Describe the purpose of your study
: Describe the purpose of your study by writing a statement that completes the following sentence, "The purpose of this study is to..." (two to three sentences)
|
|
Write a paper about persuasion of the american people
: Write a paper about "Persuasion of the American People".
|
|
Grand champion, inc., purchased america''s sweethearts corpor
: Using the information from RE12-9, assume that three years later the fair value of America's Sweethearts is $720,000. Of this fair value, $350,000 is attributable to identifiable assets and liabilities. Calculate the impairment loss (if any) and reco..
|
|
Hollow shaft of uniform circular cross-section
: Problem 3: For a solid or hollow shaft of uniform circular cross-section throughout its length, the theory of pure states that:
|
|
Write a summary paper about the given article
: Write a summary paper about the article "Shale Stickiness and Drill Bit Balling: Theory and Case Histories of Problems and Solutions in Louisiana and Gulf of Mexico"
|
|
What is validate scope and why is it important to project
: What is "validate scope" and why is it important to the project?
|
|
Describe the procedure you used to collect data
: Introduction : In 100-200 words, use this section to interest your audience in the issue or question of your study while using minimal background information and definitions. Materials and Methods : In 50-100 words, describe the procedure you used ..
|
|
What is the largest peak value of impulse voltage
: What is the largest peak value of impulse voltage that can be applied to a test object of 10nF - Find the output terminal voltage and the peak-to-peak ripple - What will be the multiplication factor for each of the low voltage voltmeter readings.
|