Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
My project title is grid connected hybrid pv-wind power system.
You need a specification of the system.
For system a matlab and homer software simulation design/prototype is needed.
At the same time the environmental, economic, comparisons, technical analysis is needed.
All the analysis should have proper graph. The whole report should be plagiarism free and should be with proper Harvard referencing.
The amount of referencing should be 80-100.
The detailed specification should be provided if I go through the process later on.
Would you please able to give me a rough quotation please?
1. Determine the firing angle α to obtain the rated torque at 1200rpm. 2. Compute the firing angle for the rated breaking torque at -1800rpm.
A Si pn junction diode is described by its I-V equation, I?= Is exp (V?/V?) ,where V?=25mV, Is=10-14A . It is desired to derive constant drop and PWL models for the diode assuming an operating current between 1mA and 3mA.
The armature of a separately excited (fixed field) DC motor with the parameters given below is to be driven from a single switch DC Chopper. Draw the circuit diagram for the circuit and sketch the waveforms for the motor voltage and current.
constructed using standard value resistors a. Without making a single calculation, which resistive element will have the most voltage across it Which will have the least b. Which resistor will have the most impact on the total resistance.
Design combination circuits that generates the -ve of a give 4-bit +v signed number, e.g. if it is +2 the circuit will generate -2 and if it is -2 the circuit will not change it. assuming that the signed number is in 1's complement representation.
When carrying out an FFT of a cosine wave whose frequency is 0.1Hz and whose amplitude is unity , explain why the peak amplitude measurement obtained in the range 0.09Hz to 0.11Hz should be 0.5
In what way does the use of deterministic annealing offer an advantage over maximum-likelihood estimation in such a situation?
The plant contains six 288MW generators. Given the overall facility efficiency is 76%, and the plant is capable of full output for a duration of 5 hours, determine the potential energy of upper reservoir and the minimum amount of water in gallons ..
If the SNR must be greater than 40 dBm, how far backed-off must the amplifier operate. Assume noise comes from a third-order intermodulation between two interferers with the same power level as the wanted signal.
Describe how you would use the voltage follower so the output load voltage (as measured with a scope probe) agrees with the value shown on the function generator front panel independent of load impedance. Describe any compromises or inefficiencies..
Assume that we have an image represents a sinusoidal variation orthogonal to the x-axis with amplitude of 10 and period of 1 cm, that repeats infinitely in all directions within the plane. Further assume an average intensity of 10.
A rectagular waveform has a 50% duty cycle (hight for 1/2 a cycle and low for 1/2 a cycle). It goes between two voltage levels of -3 V (low) and +8 V (high), and has a period of 100 μs. determine the average voltage of this waveform and the RMS vol..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd