Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 78 Ohm lossless planar line was designed but did not meet a requirement. What fraction of the widths of the strip should be added or removed to get the characteristic impedance of 75 Ohms?
Design a circuit that might be used as a trigger for a night-light. You are given a photoresistor whose resistance changes from 5k when inside a lighted room to 30k in a dark room. Design a voltage divider circuit that will provide a 3V
Given a coaxial cable with solid inner conductor of radius a, an outer conductor that goes from radius b to c (so c>b>a), a charge +Q that is assumed evenly distributed throughout a meter length of the inner conductor
Use Smith Chart: A 100 Ohm air-coaxial transmission line is measured to have an input impedance of 100 + j100 Ohms. If the system is operated at 100 MHz and is one meter long, what is the terminating load impedance
A p-channel JFET operating at VSG = 0 is connected in series with a power supply V and a resistor R = 10 k. Ithas been found that for V 12 V the voltage across R is constant at 10 V. What are IDSS and VP for this FET
A MOSFET differential amplifier such as that is biased with a current source I=200uA. The transistors have W/L=25, k'n=200uA/V^2, VA=200 V, Cgs=40 fF, Cgd=5 fF, and Cdb=5 fF. The drain resistors are 20k-ohm each.
Determine the energy uses on farms in middle east and determine whether or not it is better to use a stand alone system or a grid connected system for the application on farms.
It is used in a quarter Wheatstone bridge with three other fixed 100 W resistors. If the strain gauge constant is 2.0, find the output voltage when the input voltage to the bridge is 10 Volts and the strain is 500 m strain.
A Gaussian beam has a waist of 1.0 mm located 20.0 cm away from a thin converging lens of focal length 10.0 cm. If the wavelength of the source is 633 nm, what is the size and location of the output waist.
The pulse generator circuit accepts a 16 Hz pulse and converts the signal to a 1 Hz pulse, that is, a clock signal once every second. This signal is then used to drive a counter that controls how the lights are illuminated.
Fortunately, for this purpose, we can replace multiplication with switching operation. A similar observation applies to demodulators. In the scheme depicted in fig p7-40a, the period of the rectangular periodic pulse x(t) shown in Fig. P7-40b is T..
q1. let us consider a three-phase balanced y-connected source with vab400 30angv rms and 50 hz. this source supplies
There is some interest from industry to be able to track the solidification or drying of the paint layer as it happens to ensure correct thickness and material properties. One way to do this would be to measure the changing values of the permittiv..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd