Fraction of the herbicide

Assignment Help Civil Engineering
Reference no: EM1382869

The herbicide 2,4,D, is applied to a golf course at a rate of 1.2 kg/ha. The organic matter content of the soil is 1%, bulk density is 1.3 g/cm3, and water content is 0.3.

a) What fraction of the herbicide is adsorbed, and what fraction is dissolved?

b) If the golf course is irrigated at a rate of 1.6 cm/day and the actual grass water use rate is 0.4 cm/day, how long will it take for the 2,4-D to reach the water table at a depth of 2 meters? Assume a constant and uniform soil water content of 0.3.

c) How much (kg/ha) of the dissolved herbicide will remain when it reaches the water table? Use the decay constant for Ouachita soil and grass.

d) By how much will the ground water concentration of 2,4-D increase if the herbicide mixes into 2 cm of saturated thickness with a porosity of 0.5?

Reference no: EM1382869

Questions Cloud

Presentation on trickster : Prepare a presentation on the trickster. Identify a figure from contemporary popular culture that is not explicitly drawn from mythology.
Do you think the reasons for rules and tradition : Do you think the reasons for rules and tradition for communication at your workplace apply to academic writing.
Removing 1000 cubic kilometers per year from rivers : There is approximately 2,000 cubic kilometers of water stored in rivers around the world. Using the terms water cycle, flux and pool, explain under what situations removing 1000 cubic kilometers per year from rivers for human use could be sustainable..
Discuss how decision analysis could be used to solve : Select an organization you have worked for or any organization of interest and discuss how decision analysis could be used to solve a business problem.
Fraction of the herbicide : The herbicide 2,4,D, is applied to a golf course at a rate of 1.2 kg/ha. The organic matter content of the soil is 1%, bulk density is 1.3 g/cm3, and water content is 0.3. a) What fraction of the herbicide is adsorbed, and what fraction is dissolve..
Write main advantage of using domain controlled network : Write down the main advantages to using Domain controlled network? Write down some concerns and disadvantages to switching to domain network?
Minority group relations in america : Critically discuss ethnic and minority group relations in America according to each of the three theoretical perspectives (functionalist, conflict, symbolic interactionist)
Will herb successful in an action brought against employee : Three weeks after starting the job Herb was fired without cause and replaced by the employer's friend. Will Herb be successful in an action brought against the employer for breach of contract?
Corporate accounting assignment : Write a report the owners detailing ALL the different options and considerations that you feel the owners should consider raising the $60 million.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Construction of the embankment

Pore water pressure is to be observed during the construction of the embankment. Calculate the pore water pressure which must not be exceeded at any point in the clay layer 9 m below the surface of the embankment to ensure a shear strength of 100 ..

  Related geotechnical engineering

This material is related Geotechnical Engineering, please only answer if you are certain and sure of your answer. An undisturbed soil sample has a dry unit weight of 112 pcf with a specific gravity of solids equals to 2.68.

  Mannering traffic and highway engineering

An approach to a pretimed signal with a 60 sec cycle has nine vehicles in the queue at the beginning of the effective green. Four of the nine vehicles in the queue are left over from the previous cycle.

  Percent by weight of limestone

A slurry containing 20 percent by weight of limestone (CaCO 3 ) is processes to separate pure dry limestone from water. If feed rate is 2000kg/h, how much CaCO 3 is produced per hour?

  Horizontal and vertical component from this acting force

What would be the Horizontal and vertical component from this acting force see diagram

  Determining axial load of a dense sand

A dense sand has an effective friction angle of 43 and c'=0. A dry, 2.8-inch diameter sample is tested in drained triaxial shear with a confining pressure of 2500 psf. What axial load, P (in pounds), will be required to fail the sample?

  Analyze a structural system of a building

Use modern software tools to analyze a structural system of a building.

  Determining optimal solution

The company would like to distribute the songs between the two CDs such that the used space on each CD is about the same. Formulate the problem as an IP, and find the optimal solution.

  Freeways density and level of service

What will the freeway's density and level of service be before and after the ban? (Assume that the trucks are removed and all other traffic attributes are unchanged).

  Force exerted by the hydraulic cylinder

The gate is rectangular with a horizontal width of 2m perpendicular to the paper. For a depth h = 3m of water, calculate the required force exerted by the hydraulic cylinder to keep the gate just closed.

  Calculating sand shear strength

Estimate the effective friction angle for the sand (assume c' = 0). Calculate the sand's shear strength (τf) on a horizontal plane at depths of the 20 ft and 50 ft.

  Write a paper on steel sustainability

Write a paper on steel sustainability.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd