Four forces act on a small airplane

Assignment Help Civil Engineering
Reference no: EM13533374

1.The slope distance and zenith angle measured from point P to pointQ were 1876.253m and 87.33'24 degrees, respectively. The instrumentand rod target heights were equal. If the elevation of point P is227.965m, above datum, what is the elevation of point Q?

2.Four forces act on a small airplane in flight: its weight (24kN), the thrust provided by the engine (10 kN), the lift providedby the wings (23 kN), and the drag resulting from its motionthrough the air (3 kN). Determine the resultant of the four forcesand its line of action with respect to the axis of the plane. Thetail of the plane is 10 degrees below the x-axis.

Reference no: EM13533374

Questions Cloud

Calculate the consolidation settlement expected : For the profile shown, the initial ground water table is 5 ft belowthe surface. A proposed dewatering project will cause the watertable to drop 10 ft from the original level. Consolidation tests performed on clay samples produced the following result..
Find the normal strains in these two directions : If the normal stresses in the x and y direction are given byσx and σy, find the normal strains in these two directions.
Determine the rate of evaporation of water : Water is to be boiledat sea level in a 30 cm diameter stainless steel pan on top of a3-kW electric burner. If60% of the heat generated by the burner is transferred to thewater during boiling, determinethe rate of evaporation of water.
Determine which is a better site for wind power generation : Two sites are being considered for wind power generation. In the first site, the wind blows steadily at 7 m/s for 3000 hours per year, whereas the second site the wind blows at 10m/s for 2000 hours per year
Four forces act on a small airplane : The slope distance and zenith angle measured from point P to pointQ were 1876.253m and 87.33'24 degrees, respectively. The instrumentand rod target heights were equal. If the elevation of point P is227.965m, above datum, what is the elevation of poin..
How long will it take him to reach the same velocity the : For the free-falling patachutist with linear drag, assume a firstjumper is 70 kg and has a drag coefficient of of 12 kg/s. If a second jumper has a dragcoefficient of 15 kg/s and a mass of 75 kg, how long will it take him to reach the same velocity t..
Provide your code for completing curve fitting : Plot ω vs t, marked by red stars. Label the x-axis, t,and the y-axis, ω. Give the plot a suitable title. Add a legend to the plot describingthe relationship between ω and t. Change the y-axis scale to show the plotfrom estimate ω is -100 to 1100.
Balance the following acid base neutralization reaction : Balance the following acid base neutralization reaction. Identifythe acid and the number of equivalents per mole. Identify the baseand the number of equivalents per mole.
Determine the pressure rise in the tire when the air : The pressure in a tire depends on the temperature of the air in atire. When the air temp is 25 C, the pressure gage reads 210KPa. If the volume of the tire is 0.025 m3

Reviews

Write a Review

Civil Engineering Questions & Answers

  What microbial mediated process do suspect is occurring

find a chlorine demand occurring in your drinking water distribution system (series of pipes that carry drinking water throughout a city), yet there is no increased chlorine demand in the water going through the treatment plant

  Determine the maximum normal strain developed in the board

The man has a mass of 65kg and stands motionless at the end of the diving board. If the board has the cross section, determine the maximum normal strain developed in the board. The modulus of elasticity for the material is E = 117GPa

  Determine the radial dimension r as a function of z

The pedestal supports a load P at its center. If the material has a mass density p, determine the radial dimension r as a function of z so that the average normal stress in the pedestal remains constant.

  What is the smallest number of bulbs to be purchased

A company manufactures a brand of light bulbs with a lifetime in month that is normally distribute with a mean=3 and a variance=1. A consumer buys a number of these bulbs with the intention of replacing them successively as they burn out.

  Draw the influence line for the support reaction

Draw the influence line for the support reaction at A and calculate the support reaction at point

  What stack height should be used to assure concentrations

A paper plant is proposed for a location 1 km upwind from a town. It will emit 40 g/s of hydrogen sulfide, which has an odor threshold of about 0.1 mg/m 3. Winds at the effective stack are typically 4 m/s blowing toward the town.

  Find the surface water elevation of reservoir c

If the pipe lengths ar L1 = 3000ft, L2 = 2200, and L3 = 1600 ft the respective pipe diameters are 15,10, and 18in, and the surface water elevations of two of the three reservoirs are A = 125ft and B = 55ft, find the surface water elevation of Rese..

  Find the swell and shrinkage and load and shrinkage factors

material (LCY) in 12 yard dump trucks, placing it, and compacting the weight of the soil is 3,750 lb/cu.yd. (30 pts.) (show your calculations) a) Find the Swell and Shrinkage b) Load and Shrinkage Factors

  Calculate the residence time of the treatment cell

Consider a rectangular wastewater treatment cell having a length of 100ft, width of 20ft and depth of 20ft. If the flow into the cell is 50ft^3/min, calculate the residence time of the treatment cell.

  Determine the magnitude of f2 which will cause the reaction

Determine the magnitude of F2 which will cause the reaction Cy at the bearing C to beequal to zero. The bearings are in proper alignment and exertonly force reactions on the rod. Set F1 = 550 lb.

  Find bod reaction rate constant of a municipal waste water

If the BOD5 of a municipal wastewater is 310 mg/L and the BODU is 340 mg/L, determine the BOD reaction rate constant (base e). What would be the 3 day 30°C BOD Assume, temperature coefficient = 1.047.

  Calculate the depth of flow upstream of the bridge

A bridge has cylindrical piers 1 m in diameter and spaced 15 m apart. Downstream of the bridge where the flow disturbance from the piers is no longer present, the flow depth is 2.9 m and the mean velocity is 2.5 m/s.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd