For the purpose of redesigning their manufacturing process

Assignment Help Basic Statistics

Reference no: EM13640506

A 2³ factorial is used by an a process engineer to study the effects of cutting speed (A), tool geometry (B), and cutting angle (C) on the life (in hours) of a machine tool. Two levels of each factor are chosen, and duplicates were run at each design point with the order of the runs being random. The data are presented below.

Treatment Combination Life

(1) 22,31

a 32,43

b 35,34

ab 35,47

c 44,45

ac 40,37

bc 60,50

abc 39,41

a) Calculate all the sums of squares (i.e., SS_A, SS_B, SS_C, SS_AB, SS_AC, SS_BC, and SS_ABC)

b) Develop your ANOVA table in which SS, MS, DF, and F should be shown

c) Based on the F values in part (b), which factors and/or interactions are significant?

d) For the purpose of redesigning their manufacturing process, they want to know the most important factor. What would that be?

e) Using Minitab, obtain the ANOVA table

f) Check if the three assumptions are met [ USE Minitab for the plots and write conclusions]

g) Using Minitab, obtain the Pareto chart. What are your conclusions from the Pareto chart?

Reference no: EM13640506

Questions Cloud

Two students a and b are both registered for a probability : two students a and b are both registered for a probability class. neither student has a sterling attendance pattern.

Determine for the cycle the mass flow rate of condenser : water is the working fluid in an ideal rankine cycle. superheated vapor enters the turbine at 8 mpa 480 oc. the

Water drips from the nozzle of a shower onto the floor 203 : water drips from the nozzle of a shower onto the floor 203 cm below. the drops fall at regular equal intervals of time

A bullet is fired through a board 140 cm thick with its : a bullet is fired through a board 14.0 cm thick with its line of motion perpendicular to the face of the board. if it

For the purpose of redesigning their manufacturing process : a 23nbspfactorial is used by an a process engineer to study the effects of cutting speed a tool geometry b and cutting

In order to pass the full pump flow through the valve at : a pressure relief valve contains a poppet with a 4.20 cm2 area on which system pressure acts. during assembly a spring

A stationary radar operator determines that a ship is 13 km : a stationary radar operator determines that a ship is 13 km south of him. an hour later the same ship is 25 km

The contact length and force are 25 in and 1 ton : the wheel of a crane lift is rolling on a flat rail. the radius of the wheel is 4 in the contact length and force are

In the manufacturer sector the types of items measured for : in the manufacturer sector the types of items measured for example average call times product weights container volumes

User Account

All Pages