For an undamped sdof spring mass system m5kg and k2000 nm

Assignment Help Mechanical Engineering
Reference no: EM13626090

For an undamped SDOF spring mass system m=5Kg and k=2000 N/m. Plot the displacement and acceleration of the system using matlab if initial displacement is 0 and initial velocity is 0.6 m/s.

Now consider another case where the initial displacement is 0.2m and the initial velocity is 0 m/s. Make sure each plot as at least 5 cycles.

Part 2:

assume that a viscous damper is added to the system so the damping ratio is 20%, plot the response.

Reference no: EM13626090

Questions Cloud

He is using a two sample z-test to try to prove his : you are standing in line at the super market when a scientist standing behind you strikes up a conversation with you.
The vertical load on the hook is 1000 lb draw the : the vertical load on the hook is 1000 lb. draw the appropriate free-body diagrams and determine the maximum average
What is the energy balance equation for the compbined pump : a water pump is attached to an electric motor. the inlet and outlet diameters of the pump are the same. the volume flow
When drilling a hole in a table leg a furniture maker uses : when drilling a hole in a table leg a furniture maker uses a hand-operated drill with a bit of diameter d4.0mm.a. if
For an undamped sdof spring mass system m5kg and k2000 nm : for an undamped sdof spring mass system m5kg and k2000 nm. plot the displacement and acceleration of the system using
Compute the design factor of a rod that is under a tensile : compute the design factor of a rod that is under a tensile load of 3125 lb. the rod is rectangular 1.5 in by 3.5 in and
Provide an appropriate response describe a run chart and : provide an appropriate response. describe a run chart and give an example. refer to the values on each of the axes as
Consider water as the substance at 30 bar and 450c : consider water as the substance at 30 bar and 450c.a calculate specific volume m3kg using ideal gas equation of state.b
Consider condenser in a vapor power plant in which steam : consider condenser in a vapor power plant in which steam from the turbine is condensed to saturated liquid by rejecting

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Water flows through a shower head steadily at a rate of

water flows through a shower head steadily at a rate of 10lmin. an electric resistance heater placed in the water pipe

  What would happen if the air filter was partially choked

What would happen if the air filter was partially choked. If the piston rings were leaking state what you would expect the results of a, b, c, and d above would be.

  Plot the maximum efficiency of a nuclear power plant as a

the environment in a certain area is 15 degrees c. plot the maximum efficiency of a nuclear power plant as a function

  Part-1link parametersbull a draw a cad model of an rr link

part-1link parametersbull a draw a cad model of an rr link shown in fig.you may represent an r joint as in fig or using

  Calculate the mass of mixture produced at the mixing stage

calculate the mass of mixture produced at the mixing stage, the mass jam produced from the kettle and the mass od water evaporated from the kettle.

  The tank is allowed to exchange heat with the surroundings

a tank of compressed air is at 40 degrees c and 10 atm. 1 third of the gas is removed for inflating a car tire. the

  A particular system obeys the relation uau-2expsr n moles

a particular system obeys the relation uau-2expsr n moles of this substance initially at temperature to and pressure po

  Discuss the factors beyond crystal structure

Discuss the factors beyond crystal structure, quenching and temperature that affect he results of a specimen in a Charpy V notch impact testing.

  Calculate the heat transfer of the plate the bottom is

air with natural convectionno flow 20 degree c surrounds a flat plate. the plate is 100cm long 50cm wide and 2cm

  You may assume there is no change in both potential and

a paddle wheel is inserted in a 0.6 m3 rigid well-insulated tank which is filled with 2 kg of air. the paddle wheel

  Draw a schematic of the turbine as a control volume label

steam having pressure 4.0 mpa and temperature of 880 k enters the turbine installed in a power plant at the rate 500

  The pendulum consists of a plate having a weight 12 lb and

1.the block brake is used to stop the wheel from rotating when the wheel is subjected to a couple moment m0. determine

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd