Fluid flow axially in annular region between two concentric

Assignment Help Mechanical Engineering

Reference no: EM13714089

A fluid flow axially in the annular region between two concentric pipes with radii R1 and R2>R1, respectively. Assume the flow is steady, incompressible, axisymmetric, fully-developed, and has no swirl. Also neglect all body forces.

a) Write out the governing equations in cylindrical polar coordinate form and simplify for the above assumptions.

b) Write down all applicable boundary conditions.

c) Integrate the resulting equations to obtain a velocity profile for the fluid in the annular region, u_z(r). Do not try to determine the constants of integration

PLEASE SHOW ALL WORK FOR EACH STEP FOR 5 STARS

Reference no: EM13714089

Questions Cloud

Ocean thermal energy conversion power plant : An Ocean Thermal Energy Conversion (OTEC) power plant built in Hawaii in 1987 was designed to operate between the temperature limits of 86°F at the ocean surface and 41°F at a depth of 2100 ft.

Required for annealing process using lumped system analysis : A long steel bar of radius R = 2.5 cm, k =50 W/(m .°C), p = 7800 kg/m3, and c = 0.5 kJ/(kg. .°C) is to be annealed by cooling slowly from 800.°C to 100.Â°C in an environment at temperature 50.°C. If the heat transfer coefficient between the environme..

Steam power plant operates between the pressure limits : A steam power plant operates between the pressure limits of 4.5MPa and 15kPa. Steam enters the pump as saturated liquid and leaves the turbine as saturated vapor. Determine the ratio of the work delivered by the turbine to the work consumed by the pu..

Fluid flow axially in annular region between two concentric : A fluid flow axially in the annular region between two concentric pipes with radii R1 and R2>R1, respectively. Assume the flow is steady, incompressible, axisymmetric, fully-developed, and has no swirl. Also neglect all body forces.

Assume that the tunnel operates adiabatically : A hypersonic gun tunnel is used to generate short-duration, high-speed flows and typically consists of two cylindrical volumes separated by a diaphragm. One end of the tunnel (the driver end) is pumped to a high pressure, while the other end (the dri..

Pressure-angle helical pinion with a right-hand helix : A 17-tooth 20 normal pressure-angle helical pinion with a right-hand helix angle of 30 rotates at 1800 rev/min when transmitting 4 hp to a 52-tooth helical gear. The normal diametrical pitch is 10 teeth/in, the face width is 1.5 in, and the set has a..

Analysis for both pinion and gear-hardness values : A cable drum for a crane is to rotate between 160 and 166 rpm. Design a gear drive for 25 hp in which the input pinion rotates at 925 rpm and the output rotates with the drum. The crane is expected to operate with a 50% duty cycle for 120 hours per w..

Determine the rate of heat transfer to the rods in the oven : Long cylindrical steel rods (p=7833kg/m3 and cp=0.465kJ/kg*°C) of 8-cm diameter are heat treated by drawing them at a velocity of 4m/min through an 8-m-long oven maintained at 900°C. If the rods enter the oven at 25°C and leave at 750°C,

User Account

All Pages