First law of thermodynamics

Assignment Help Mechanical Engineering
Reference no: EM13701703

First Law of Thermodynamics:

1. Stone Mountain near Atlanta, GA has a sky ride which a gondola is suspended from a cable that takes people to the top of Stone Mountain as well as back down. [MO4, MO5, MO6]

2. Using the First Law of Thermodynamics, what would be the most efficient way to design this ride?

3. Discuss if this might be used to generate rather than use electrical energy. If so, what would be required? If not, why not?

Reference no: EM13701703

Questions Cloud

Electrical energy into mechanical work : If you knew how much voltage you would generate with a given device and you needed to convert that electrical energy into mechanical work, how would you go about doing that?
Maintain the heated space at a constant temperature : A heat pump is used to heat a building. The outside air temperature is -10 C and the desired inside temperature is 20.3 C. The heat loss through the walls, ceiling, etc, is 30 kW. Determine the ideal coefficient of performance and the minimum power r..
Number of watts that must be supplied to the compressor : A Carnot refrigerator using R-134a absorbs heat from a refrigerated space at 0oC and rejects heat to a kitchen at 27oC.The refrigerant enters the evaporator with a quality of zero and exits with a quality of one. The operating pressure of the evapora..
Combustion process taking place in a sealed container : In a combustion process taking place in a sealed container, 160kg of methane is burned in 560kg of O2 and 1845kg of N2 to yield CO, CO2, H2O and N2 as the products of combustion. How many kg of CO are produced?
First law of thermodynamics : Stone Mountain near Atlanta, GA has a sky ride which a gondola is suspended from a cable that takes people to the top of Stone Mountain as well as back down. [MO4, MO5, MO6]. Using the First Law of Thermodynamics, what would be the most efficient way..
Determine the thermodynamic efficiency and back work ratio : A regenerative gas turbine is planned to operate with inlet conditions of 100 kPa and 300 K, a pressure ratio of 6, a turbine inlet temperature of 1600 K, and a net power output of 150 kW. The effectiveness of the regenerator is 90% and the adiabatic..
Regenerator as well as reheating and intercooling : Air enters a THREE STAGE gas turbine at 100 kPa and 17 degree Celsius. This system uses a regenerator as well as reheating and intercooling.
What speed should the wind tunnel be run : A 1/10th scale model of an airplane is to be tested in a wind tunnel that operates with air at a pressure of 20 atmospheres. The plane is expected to fly at a speed of 500 [km/hr]. What speed should the wind tunnel be run?
What is the density of the vapor : A 3 liter vessel contains 2kg of water, 0.05kmol of steam, and 15cm^3 of ice (of density 990 kg/m^3). If the vessel is heated until its entire contents have vaporied, what is the density of the vapor?

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Asuming a constant pressure specific heat for air of cp

air enters the compressor of an ideal-gas refrigeration cycle at 270 k and 110 kpa and the turbine at 325 k and 440 kpa

  A heat pump is executed with r-134a under the saturation

a heat pump is executed with r-134a under the saturation dome between the pressure limits of 1.6 mpa and 0.2 mpa. if

  Water at 300 kpa with a quality of 50 has a temperature

water at 300 kpa with a quality of 50 has a temperature raised 20oc in a constant pressure process. what is the new

  Determine the amount of heat transfer when this is done

in a close stationary system 2 kg of argon is heated from 20oc to 120oc. determine the amount of heat transfer when

  The critical stress in mpa required for crack propagation

for a brittle material that has a crack of length 0.04mm and flexural strength and elastic modulus values of 88.1 mpa

  When the spring is loaded vertically with 1 kg weight it is

a spring with a wire diameter of 1mm and 20 turns of radius 10 mm was given to you. the weight of the spring is 4 g.a

  Find the desired radius and mass of the absorber

Find the desired radius and mass of the absorber if the absorber is to not exceed an angular deflection amplitude of 30 degrees when the engine is running at 750 rpm.

  Calculate the acceleration of the rocket at liftoff obtain

a large two-stage liquid rocket with mass of 30000 kg is to be launched from a sea-level launch pad. the main engine

  An inventor claims to have devised a refrigeration cycle

an inventor claims to have devised a refrigeration cycle that at steady state requires a net power of .8 hp to remove

  Considering air inside the cylinder as the system calculate

consider a vertical piston-cylinder assembly with a 50 kg piston attached to a spring and exposed to atmospheric

  The corresponding mass flow rates not the original

incoming air flow of 200 m3h at a temperature of 20oc and a humidity ratio of 0.012 kgvkga is mixed in a chamber with

  An airplane used to drop water on brushfires id flying

an airplane used to drop water on brushfires id flying horizontally in a straight line at 180 mih at an altitude of

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd