Finding out coding gain of a dsss-cdma transmitter

Assignment Help Electrical Engineering
Reference no: EM13138413

Evaluating Coding Gain, CNR, and BER of a DSSS-CDMA Transmitter
a. A DSSS-CDMA transmitter sends message signals at a rate of 5.0 kbps using a long chip sequence with a rate of 1 M chips per second. In the receiver, what is the processing gain (also called coding gain) in dB?

b. The receiver in part (a) above pick up a weak signal with CNR = -10 dB. Assuming no losses in the receiver correlation process, what is the CNR of the recovered baseband signal?

c. If the modulation of the signal in part (b) above in is BPSK, would the BER in the recovered message signal be below 10-6?

d. The receiver in part (b) above must use an IF correlator rather than a baseband correlator. Why?

e. What special feature of Barker codes make them useful in DSSS-CDMA systems that employ a short chip sequence?

Reference no: EM13138413

Questions Cloud

Probability distribution used to find chance of right answer : Select the answer for each question. What type of probability distribution can be used to figure out her chance of getting 10 questions right?
What are the total period costs incurred this period : What are the total Period Costs incurred this period?
Determiningt the correct adjusting entry : The annual interest rate on the mortgage payable was 7.75 percent. Interest expense for one-half month should be computed because the building and land were purchased and the liability incurred on June 16. What should the correct adjusting entry b..
What is the change in volume of the balloon : A sealed balloon is filled with 1.00 L of helium at 23 degrees celsius and 1.00 atm. The baloon rises to a point in the atmosphere where the pressure is 220 torr and the temperature is -31 degrees celsius.
Finding out coding gain of a dsss-cdma transmitter : Evaluating Coding Gain, CNR, and BER of a DSSS-CDMA Transmitter, a. A DSSS-CDMA transmitter sends message signals at a rate of 5.0 kbps using a long chip sequence with a rate of 1 M chips per second. In the receiver, what is the processing gain (a..
What was the amount of raw materials used during quarter : What was the amount of Raw Materials used during this quarter?
Incedence of international terrorism : To what extent does realist theory help to explain the incedence of international terrorism What specific should be developed?
What is willis ebitda coverage ratio : It has $2 billion in lease payments and @1 billion must go toward principal payments on outstanding loans and long term debt.What is willis EBITDA coverage ratio?
What might ronald do to alleviate this cash crunch : Ronald needs $1,215,650 to cover next Friday's payroll. Its balance of outstanding accounts receivable totals $1,277,000. What might Ronald do to alleviate this cash crunch?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Traffic light controller

The schematic of the traffic light controller

  Determine a suitable sampling frequency

Determine a suitable sampling frequency. Design a notch filter to remove the 50Hz component, paying particular attention to any assumptions you have made in the design.

  Explain how an electric shock may occur

A process worker received an electric shock when she attempted to turn off a conveyer control. The toggle switch controlled the power to a variable speed drive. An examination found that dust had accumulated on the toggle switch. Moisture on the ..

  Calculate the inverse fourier transform

Compute the inverse Fourier transform for X(ω) = cos 4ω. 5. A signal with the highest frequency component at 10 kHz is to be sampled. To reconstruct the signal, the sampling must be done at a minimum frequency of?

  Implementation of the project:

Implementation of the project with the analog and digital modulation techniques

  Define maximum amount of channels a link can carry

Maximum Amount of Channels A Link Can Carry, A microwave radio link operates over a bandwidth of 400 MHz at C band. The link carries a number of channels of data using FDMA.

  Basic column control

The basic column control system shown in Figure is somewhat more complicated than the basic neutralizer control system

  Electricity and circuit theory

Assessment on Electricity and Circuit Theory,  What part of a cable are insulators and conductors? Describe, in terms of charged particles, why some objects are electrically attracted to each other, while others repel each other?

  What is the time response

What is the time response

  Depiction impedance diagrams

Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.

  Evaluate laplace transforms

Analyse and Model Engineering Situations and Solve Engineering Problems using Laplace Transform

  Future generation telecommunication technology

Write a report on Future Generation Telecommunication Technology.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd